Doctor Blade Tape Casting of In-based Low Melting Point Alloy
نویسندگان
چکیده
منابع مشابه
TAPE CASTING OF NON-AQUEOUS HYDROXYAPATITE SLIPS
Thin sheets of hydroxyapatite were fabricated by tape casting process. The non-aqueoustape casting formulation was optimized by adjusting the concentration of organic additivesspecially those of binder and plasticizer in the slurry. The optimized slurry was cast on a glasscarrier using a designed laboratory scale doctor blade. Following a binder removal stage, thetapes were sintered at differen...
متن کاملEthanol-based Tape Casting Process of the Textured Bi0.5(Na0.80K0.20)0.5TiO3-BiFeO3 Ceramics
The rheological and tape casting behavior of ethanol-based Bi0.5(Na0.80K0.20)0.5TiO3-7 mol% BiFeO3 (BNKT-BF) slurries was investigated. The effect of sintering temperature profile on texture development with a preferred orientation was also studied. A 50 MPa pressure assisted three step sintering profile promoted extensive texture development together with densification. The role of BF as a sin...
متن کاملPreparation of hexaferrite multilayers by tape casting
Tape casting technics were used to realize a screen with continuous change in characteristics. Different hexaferrite compositions owned by the Ba3C02-~Zn~Fe24041 (Z) family were synthetized by coprecipitation method and calcined at 1200 "C in air. Then a slurry containing this powder is slip casted using tape casting. The tapes are dried under magnetic fied in order to orient the magnetic plate...
متن کاملInvestigation of the mechanical properties of various yttria stabilized zirconia based thin films prepared by aqueous tape casting
In this study various yttria doped zirconia based thin films were prepared by the aqueous tape casting method. The rheological property of the paste was studies. The phase content and microstructure of the samples was investigated by X-ray diffraction and scanning electron microscope, respectively. The mechanical properties of thin films were studied by Vickers microhardness and nanoindentatio...
متن کاملDental casting of superelastic Ni-Ti alloy.
Rods of Ni-43.5wt% Ti alloy were prepared under various casting conditions. Specimens which were melted in a cordierite crucible and cast in a phosphate-bonded investment mold had less strength and elongation than those melted in a copper crucible and cast in a phosphate-bonded investment mold. All castings exhibited superelasticity at room temperature. The upper limit of recoverable strain was...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Korea Foundry Society
سال: 2015
ISSN: 1598-706X
DOI: 10.7777/jkfs.2015.35.3.062