Diversified Reactor Level Measurement System in the Boiling Water Reactor of Olkiluoto
نویسندگان
چکیده
منابع مشابه
REACTOR PHYSICS CALCULATIONS ON MOX FUEL IN BOILING WATER REACTORS (BWRs)
The loading of MOX (Mixed Oxide) fuel in BWRs (Boiling Water Reactors) is considered in this paper in a “once-through” strategy. The fuel assemblies are of the General Electric 8×8 type, whereas the reactor is of the General Electric BWR/6 type. Comparisons with traditional UOX (Uranium Oxide) fuel assemblies revealed that the loading of MOX fuel in BWRs is possible, but this type of fuel creat...
متن کاملMeasurement of Granule Density in UASB Reactor
To monitor the granularity of anaerobic sludge, the determination of granule density is vital importance. Granular sludge is the key factor for the efficient operation of upflow anaerobic sludge blanket (UASB) reactor. For this reason several techniques have been proposed. In the proposed algorithm, the granular density was calculated. The granular density was strongly correlated with the VSS/T...
متن کاملA lattice Boltzmann framework to simulate boiling water reactor core hydrodynamics
This paper presents a consistent LBM formulation for the simulation of a two-phase water–steam system. Results of initial model validation in a range of thermodynamic conditions typical for BoilingWater Reactors (BWRs) are also shown. The interface between the two coexisting phases is captured from the dynamics of the model itself, i.e., no interface tracking is needed. The model is based on th...
متن کاملOn-Line System for Monitoring of Boiling in Nuclear Reactor Fuel Assemblies
An important goal of nuclear reactor instrumentation is the continuous monitoring of the state of the reactor and the detection of deviations from the normal behaviour at an early stage. Early detection of anomalies enables one to make the necessary steps in order to prevent further damage of nuclear fuel. In the present paper, an on-line core monitoring system is described by means of which bo...
متن کاملAdvanced Power Plant Modeling with Applications to an Advanced Boiling Water Reactor and a Heat Exchanger
Advanced methods that use continuity wave equations in fluid flow paths and exact solutions of these and all other differential equations are applied to transient performance models of a counter flow heat exchanger and an Advanced Boiling Water Reactor (ABWR). The continuity wave equations for single and two-phase flow, with heat addition, are developed, and the exact solution for a typical lea...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Energy Procedia
سال: 2017
ISSN: 1876-6102
DOI: 10.1016/j.egypro.2017.08.100