Disturbance Propagation in the Melt Spinning Process
نویسندگان
چکیده
منابع مشابه
matrix-fibril morphology and structure of polyblend fibers in melt spinning process: a review
the mechanism and the parameters affecting the matrix-fibril morphology in melt spun polyblend fibers are discussed. the properties of polymeric blends depend considerably on their final morphologies. blending of two miscible polymers, normally gives rise to formation of a single-phase morphology while blending of two immiscible polymers can create a two or three (in case of using compatibilize...
متن کاملOptimal Control of Melt Spinning Processes
An optimal control problem for a mathematical model of a melt spinning process is considered. Newtonian and non–Newtonian models are used to describe the rheology of the polymeric material, the fiber is made of. The extrusion velocity of the polymer at the spinneret as well as the velocity and temperature of the quench air serve as control variables. A constrained optimization problem is derive...
متن کاملComposite Fibers from Recycled Plastics Using Melt Centrifugal Spinning
New methods are being developed to enable the production of value-added materials from high-volume, low-cost feedstocks arising from domestic recycling streams. In this work, recycled bottle-grade polyethylene terephthalate, polystyrene, and polypropylene were spun into fibers from the melt using a centrifugal spinning technique. Mono-component fibers and 50/50 blends of each polymer and a 33/3...
متن کاملLate snow melt moderates herbivore disturbance of the Arctic tundra
Resilience of tundra vegetation to disturbance by herbivores can be low and lead to ecosystem state shifts. Pink-footed geese Anser brachyrhynchus are the most numerous herbivore on Svalbard and disturb vegetation when foraging for below-ground plant biomass (grubbing). We assessed grubbing extent (occurrence of vegetation disturbance) and intensity (proportion of vegetation disturbed) in 2006/...
متن کاملSimulation of Multifilament Semicrystalline Polymer Fiber Melt-Spinning
The goal of this effort is to provide an accurate simulation of multifilament fiber melt spinning, applicable for a wide range of material and process conditions. For ease of use, the model should run on a standard laptop or desktop computer in reasonable time (one hour or less). Most melt spinning models simulate the formation of a single filament, with little or no attention given to multifil...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: PAMM
سال: 2009
ISSN: 1617-7061
DOI: 10.1002/pamm.200910110