Distributed Module-Based Power Supply Enhancement System for 3 kV DC Traction
نویسندگان
چکیده
This paper presents a conception of 3 kV DC traction power system based on distribution sources, as an alternative to traditional substation. The consists supplying modules (SM) installed along the electrified railway line, distance between adjacent SMs are much shorter, than substations in system. Each SM energy storage (ESS), and could be charged from adjacent, substation via catenary, medium voltage lines, renewable sources or by recuperation. In article, main parameters proposed operation have been compared with For this purpose, case study, comparison analysis has carried out for losses 15-min peak demand well cost installation. At end, reliability supply one.
منابع مشابه
Measurements on 25 kV Traction Power Supply Systems
At the moment 25 kV traction power supply systems are being introduced in the Netherlands. Currently in the Netherlands a 1500 V DC system is used, however due to increasing energy demands this system is no longer sufficient. For the high-speed lines and heavy freight lines, which are under construction, the 2x25 kV AC system has been chosen. Introduction of this new technology leads to differe...
متن کاملPower Quality Improvement in Traction Power Supply Networks
AC railway traction loads are usually huge single phase loads. As a result, a significant amount of Negative Sequence Current (NSC) is injected into utility grid. Moreover, harmonics and consumption ofreactive power are further power quality problems that the supply network is encountering. In this paper, acompensation strategy with the aid of Railway Power Conditioner (RPC) is proposed to over...
متن کاملRating Reduction and Optimized DC-Link Voltage of the HPQC in Co-Phase Traction Power System
Electric traction trains are huge non-linear single-phase loads influencing adversely on power quality parameters on the grid side. Hybrid power quality conditioner (HPQC) has been utilized to compensate current unbalance, harmonics, and low power factor in the co-phase traction system simultaneously. By incrementing the traction load, the rating of the HPQC increases and may constraints its ap...
متن کاملMaximum Safety Regenerative Power Tracking for DC Traction Power Systems
Direct current (DC) traction power systems are widely used in metro transport systems, with running rails usually being used as return conductors. When traction current flows through the running rails, a potential voltage known as “rail potential” is generated between the rails and ground. Currently, abnormal rises of rail potential exist in many railway lines during the operation of railway sy...
متن کاملWireless Load Self-Disconnection Module For Automatic Power Supply System
Nowadays, the use of Auxiliary power supply (APS) systems to energize low power rating appliances (e.g. televisions, water dispensers, etc.) and lighting (e.g. CFL lamps) has become pervasive in countries where long power rationing schemes are applied. Although the existing APS systems offer overload protection, it cannot be directly connected to the existing electric circuit unless heavy loads...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Energies
سال: 2022
ISSN: ['1996-1073']
DOI: https://doi.org/10.3390/en16010401