Distributed acoustic sensor based on a two-mode fiber
نویسندگان
چکیده
منابع مشابه
Optical fiber acoustic sensor utilizing mode-mode interference.
A method for detecting sound using a single step-index multimode fiber is presented. The detected signal results from differences in acoustically induced phase shifts between two different waveguide modes propagating in the fiber. The relative sensitivity of this technique compared with a two-path interferometer was experimentally determined and agreed with that calculated using the fiber param...
متن کاملApodization of elliptical-core two-mode fiber acousto-optic filter based on acoustic polarization control.
We propose and demonstrate a novel apodization technique for an elliptical-core two-mode fiber acousto-optic filter by twisting the fiber and adjusting the acoustic polarization. The sidelobe suppression in the filter spectrum was improved from -9.7 to -15.5 dB. A theoretical analysis that includes acoustic birefringence explains the experimental results with good agreement.
متن کاملOptical Fiber Humidity Sensor Based on Lossy Mode Resonances
A novel optical fiber humidity sensor based on lossy mode resonances (LMR) has been developed. LMRs are supported here by a thin Indium Tin Oxide (ITO) coating fabricated onto an optical fiber core via a sol-gel dip coating. ITO coated optical fiber devices present a resonant maximum absorption peak in the infra-red region which is shifted to higher wavelengths when the refractive index of the ...
متن کاملCompact fiber-optic curvature sensor based on super-mode interference in a seven-core fiber.
A compact, low loss, and highly sensitive optical fiber curvature sensor is presented. The device consists of a few-millimeter-long piece of seven-core fiber spliced between two single-mode fibers. When the optical fiber device is kept straight, a pronounced interference pattern appears in the transmission spectrum. However, when the device is bent, a spectral shift of the interference pattern ...
متن کاملGas Sensor Based on Large Hollow-Core Photonic Bandgap Fiber
One concern in using photonic band-gap fiber (PBGF) as a gas sensor is the response time. In this type of the gas sensors, response time is the time required for gas to diffuse into the hollow-core. So considering a large hollow-core PBGF (HC-PBGF), the response time can be significantly reduced. But in the large HC-PBGF, the fundamental issue is the presence of higher order modes (HOMs). Somet...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Optics Express
سال: 2018
ISSN: 1094-4087
DOI: 10.1364/oe.26.025399