Dissolved oxygen sensor using platinum electrode coated with polydimethylsiloxane
نویسندگان
چکیده
منابع مشابه
Determination of Captopril using platinum coated nanoporous gold film electrode
In this article electrochemical determination of captopril at the surface of the platinum coated nanoporous gold film (PtNPGF) electrode is reported using the cyclic voltammetry and amperometry. For the preparation of PtNPGF, the surface of NPGF electrode was covered with Cu layer using underpotential electrochemical deposition (UPD).Afterward, the copper layer is replaced with platinum ions vi...
متن کاملdetermination of captopril using platinum coated nanoporous gold film electrode
in this article electrochemical determination of captopril at the surface of the platinum coated nanoporous gold film (ptnpgf) electrode is reported using the cyclic voltammetry and amperometry. for the preparation of ptnpgf, the surface of npgf electrode was covered with cu layer using underpotential electrochemical deposition (upd).afterward, the copper layer is replaced with platinum ions vi...
متن کاملScreen-printed dissolved oxygen sensor based on cerium oxide-supported silver catalyst and polydimethylsiloxane film.
A screen-printed dissolved oxygen sensor was fabricated using cerium oxide-supported silver catalyst and polydimethylsiloxane (PDMS) film. A PDMS film of 3 µm thickness showed good permeability for oxygen and impermeability for hydrogen peroxide. The calibration curve has shown a linear relationship with a correlation coefficient of 0.996 for the dissolved oxygen concentration. The sensitivi...
متن کاملOxygen Sensor with Advanced Oxide Electrode Materials
Calcium doped lanthanum and yttrium manganite electrode materials with oxygen deficiency and low polarization resistance (<30Ω*cm at 600°C) were tested in new advanced electrochemical sensor for the oxygen measurements. Oxygen sensor with oxide electrodes was showing fast response INTERNATIONAL JOURNAL ON SMART SENSING AND INTELLIGENT SYSTEMS, VOL. 5, NO. 1, MARCH 2012
متن کاملA Sensitive Dissolved Oxygen Sensor Based on a Charge-Transfer Complex Modified Electrode
A charge-transfer complex was modified on the graphite paste electrode for making a sensitive dissolved oxygen sensor. It was composed of copper with two ligands of phenanthroline and 1,2-dicyano-1,2-dithiolethane. Because of the low redox potential of the core ion and the pull and repulsive effect from the ligands, the redox of modified complex toke place under lower potential and it could sel...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEJ Transactions on Sensors and Micromachines
سال: 2000
ISSN: 1341-8939,1347-5525
DOI: 10.1541/ieejsmas.120.486