Discussion: Limit-state design for shear in rectangular and T beams

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Development of Shear Capacity Equations for Rectangular Reinforced Concrete Beams

The problem of shear is not yet fully understood due to involvement of number of parameters. Designers are extra careful about shear, especially in beams and consequently higher safety factors are used in shear design. Several equations are available in literature to determine the shear capacity of beams, i.e. ACI equation, Zsutty equation and KIM & White equation. To verify the application of ...

متن کامل

Simple Two Variable Refined Theory for Shear Deformable Isotropic Rectangular Beams

In this paper, a displacement-based, variationally consistent, two variable refined theory for shear deformable beams is presented. The beam is assumed to be of linearly elastic, homogeneous, isotropic material and has a uniform rectangular cross-section. In this theory, the beam axial displacement and beam transverse displacement consist of bending components and shearing components. The assum...

متن کامل

Experimental and Theoretical Investigation on Shear Strengthening of RC Precraced Continuous T-beams Using CFRP Strips

Carbon fiber reinforced polymer (CFRP) sheets are externally bonded to reinforced concrete (RC) members to provide additional strength such as flexural, shear, etc. It has been widely accepted that carbon fiber reinforced polymers (CFRPs) can be used effectively to strengthen reinforced concrete (RC) members. This paper is intended to study and use externally bonded CFRP strips to repair and st...

متن کامل

Shear Strength of Lightly Reinforced T-Beams in Negative Bending

Nine restrained T-beams were tested in a study of the negative moment region shear strength of lightly reinforced concrete T-beams. Variables included the longitudinal reinforcement ratio p, (0.47 percent and 0. 70 percent) and the nominal stirrup strength (0 to 84 psi [0 to 0.60 MPa]). The test results are compared with the shear provisions of "Building Code Requirements for Reinforced Concret...

متن کامل

Rehabilitation of Rectangular Simply Supported RC Beams with Shear Deficiencies Using CFRP Composites

The present study examines the shear performance and modes of failure of rectangular simply supported reinforced concrete (RC) beams designed with shear deficiencies. These members were strengthened with externally bonded carbon fiber reinforced polymer (CFRP) sheets and evaluated in the laboratory. The experimental program consisted of twelve full-scale RC beams tested to fail in shear. The va...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Magazine of Concrete Research

سال: 1971

ISSN: 0024-9831,1751-763X

DOI: 10.1680/macr.1971.23.77.192