Discussion: “Heat Transfer in an LTV Falling Film Evaporator: A Theoretical and Experimental Analysis” (Kroll, J. E., and McCutchan, J. W., 1968, ASME J. Heat Transfer, 90, pp. 201–210)
نویسندگان
چکیده
منابع مشابه
Improving Heat Transfer in Falling Film Evaporators in Food Industries
Falling film evaporators, due to their high heat transfer coefficients, low energy loss, rather a low holdup time, and the ability to handle high capacities have broad applications in food industries. Thus, this kind of evaporator is being used in the production of temperature sensitive compounds such as syrups. In this study, through modelling of the falling film evaporator with the use of...
متن کاملExperimental Investigation in Pool Boiling Heat Transfer of Pure/Binary Mixtures and Heat Transfer Correlations
Nucleate pool boiling heat transfer coefficient have been experimentally measured on a horizontal rod heater for various liquid binary mixtures. Measurements are based on more than three hundred data points on a wide range of concentrations and heat fluxes. In this investigation, it has been confirmed that the heat transfer coefficient in boiling solutions are regularly less than those in p...
متن کاملExperimental and Numerical Analysis of Flow and Heat Transfer in a Gas-Liquid Thermosyphon Heat Exchanger in a Pilot Plant
A numerical and experimental investigation of flow and heat transfer in a gas- liquid Thermosyphon Heat Exchanger "THE" with built in heat pipes and aluminum plate fins for moderate Reynolds numbers has been carried out. It's module is composed of 6 rows and 15 columns copper pipes with aluminum plate fins with dimensions of 130cm height, 47cm width and 20cm depth. The tubes have been fill...
متن کاملHeat Transfer, Mass Transfer and Scaling Characteristics in a Long Tube, Climbing Film, Pilot Plant Evaporator
ing characteristics could be investigated. Finally the pilot plant A single tube plant Kestner evaporator'was set up at was run under 1st effect conditions in order that a comparison Illovo to investigate heat transfer characteristics when could be made with industrial 1st effect evaporators (both simulating different evaporator Tests carried out have Roberts and Kestner). This particular trial...
متن کاملFlow Analysis Heat and Mass Transfer in a Room
This reports the study on the flow behaviour, heat transfer and contamination distribution in a room. For this purpose the 3-D incompressible Navier-Stokes equations, energy equation and a mass transfer equation which model the concentration of contamination have been applied. For turbulence simulation the two equation standard k- turbulence model was employed. By means of SIMPLE algorithm the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Heat Transfer
سال: 1968
ISSN: 0022-1481,1528-8943
DOI: 10.1115/1.3597478