Direct Quenching Process in Seamless Tube Manufacturing
نویسندگان
چکیده
منابع مشابه
The cooling process in gas quenching
Gas quenching is a relatively new process with several important advantages, such as minimal environmental impact, clean products, and ability to control the cooling locally and temporally for best product properties. To meet the high cooling rates required for quenching, the cooling gas must flow at very high velocities, and such flows are highly turbulent and separated. Consequently, there is...
متن کاملTwo different endotracheal tube manufacturing defects
Introduction: Although manufacturing defects related to airway equipment are not so common in practice, it risks the safety of the airway. Prompt recognition of equipment malfunction can prevent life threatening complications. Case Series: Case 1: A 25yearold patient had anesthesia induction for septorhinoplasty surgery. After the patient was ventilated via mask and intubated without problem,...
متن کاملEndotracheal Tube Obstruction: A Manufacturing Defect.
Various manufacturing defects of endotracheal tubes are encountered in anaesthesia practice. One of the important defects of an endotracheal tube is that a partial or complete obstruction can be potentially life-threatening. Manufacturing defects may not be ascertainable by routine inspection. In this case report, we report a partial airway obstruction caused by a plastic membrane in the connec...
متن کاملSeamless anesthesia care: the handover process.
673 October 2014 I N this issue of the Journal, Saager et al.1 report on a single-institution, retrospective study of care transitions (“handovers”) during intraoperative anesthesia care. Using propensity matching to control for the effects of patient variables, surgical complexity, time of day, and surgical duration, they found a significant incremental increase in the risk for an adverse post...
متن کاملInvestigating the Ultrasonic Assistance in the Tube Hydroforming Process
The purpose of introducing ultrasonic vibrations in the tube hydroforming process is to create more formability by obtaining a lower corner radius, improve thickness distribution of the wall and provide good tribological conditions at the tube and the die interface. Vibrations imposed on the die create alternating gaps which improve the formability in the tube hydroforming process in the presen...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1985
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.71.8_965