Direct Detection Receiver for W-Band Radiometer
نویسندگان
چکیده
منابع مشابه
Spira - a Scanning Polarimetric Imaging Radiometer in W-band
SPIRA is a polarimetric imaging radiometer at 91 GHz, intended for obtaining signatures of the brightness temperature distribution of the Earth surface in all four Stokes parameters. SPIRA will be transportable by two persons and be set up within hours. A radiometric sensitivity of less than 1 K will be achieved with a superheterodyne receiver at a bandwidth of 2 GHz, millisecond sampling time ...
متن کاملTypical Ka band Satellite Beacon Receiver Design for Propagation Experimentation
This paper presents the design and simulation of a typical Ka band satellite beacon receiver for propagation experimentation. Using satellite beacon signal as a reference signal in satellite wave propagation study, is one of the most important methods. Satellite beacons are frequently available for pointing large antennas, but such signals can be used for measuring the effect of natural phenome...
متن کاملReceiver for Dual Band Applications
This dual-band CMOS receiver for GSM and DCS1800 applications incorporates hardware sharing between two paths to reduce the number of off-chip components [1]. The receiver is an extension of the Weaver single-sideband architecture [2]. Utilized in References 3 and 4, the Weaver architecture performs two consecutive quadrature downconversion operations on the signal and the image such that if th...
متن کاملDetailed Noise Statistics for an Optically Preamplified Direct Detection Receiver
4Ve describe the exact statistics of an optically preamplified direct detection receiver by means of the moment generating function. The theory allows an arbitrary shaped electrical filter in the receiver circuit. The moment generating function (MGF) allows for a precise calculation of the error rate by using the inverse Fast Fourier transform (FFT). The exact results are compared with the usua...
متن کاملtypical ka band satellite beacon receiver design for propagation experimentation
this paper presents the design and simulation of a typical ka band satellite beacon receiver for propagation experimentation. using satellite beacon signal as a reference signal in satellite wave propagation study, is one of the most important methods. satellite beacons are frequently available for pointing large antennas, but such signals can be used for measuring the effect of natural phenome...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of Korean Institute of Electromagnetic Engineering and Science
سال: 2017
ISSN: 1226-3133,2288-226X
DOI: 10.5515/kjkiees.2017.28.5.426