Dimensional Change in Curing Processes of Pour Type Resin
نویسندگان
چکیده
منابع مشابه
Hardness of composite resin polymerized with different light-curing units
Introduction: The degree of polymerization depends on the type of light-curing unit. The aim of this study was to compare the hardness of composite resin cured by LED and Halogen light curing units. Methods: In this experimental study, 20 cylindrical samples of Tetric Ceram composite were prepared. Half of them were cured with Ultralume 2 LED and the other half with Astralis 7 Halogen light ...
متن کاملLight curing of dual cure resin cement
266 This is an Open Access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (http://creativecommons.org/licenses/ by-nc/3.0) which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.
متن کاملLight curing of resin-based composites in the LED era.
This review thoroughly accumulated information regarding new technologies for state-of-the-art light curing of resin composite materials. Visible light cured resin-based composites allow the dentist to navigate the initiation of the polymerization step for each layer being applied. Curing technology was regularly subjected to changes during the last decades, but meanwhile the LED era is fully e...
متن کاملCuring studies of unsaturated polyester resin used in FRP products
Fiber reinforced plastics (FRP) products being strong and light in weight, find extensive applications in automobiles, marine, structural and household components. Unsaturated polyester (UP) resin is a principle binder material used in FRP products. Curing of UP resin is a key for successful FRP processing. Gel time (tgel) and peak exothermic temperature (θpeak) are critical measures of curing ...
متن کامل[Polymerization reaction of heat curing type thermo-setting resin for crown and bridge].
The purpose of this paper is to investigate the chemical composition, the polymerization ability and the abrasion resistance of two brands (Isosit, Plastique) of thermo-setting resin for crown and bridge. 1. Isosit (Is) contained approximately 55 per cent of MFR type filler and 45 per cent of a comonomer (urethane dimethacrylate, 1, 3 butane dimethacrylate and 1, 10 decamethylene dimethacrylate...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nihon Hotetsu Shika Gakkai Zasshi
سال: 1976
ISSN: 1883-177X,0389-5386
DOI: 10.2186/jjps.20.38