Dilatometer study of rapidly solidified aluminium-silicon based alloys
نویسندگان
چکیده
منابع مشابه
Silicon particle pinhole defects in aluminium–silicon alloys
It was recently shown that silicon particles in heat-treated Al–Si casting alloys can contain flaws such as surface pinholes and grooves, which cause varying degrees of reduction in the in situ particle fracture strength and hence influence the mechanical properties of this class of alloys. In this work, we show that the formation of one class of such strength-limiting flaws in solidified and c...
متن کاملA Fim/ap Investigation of a Rapidly Solidified Aluminium-chromium Alloy
A rapidly solidified A1 6 to gwt%Cr alloy formed by vapour deposition has been studied by field-ion microscopy and atom probe microanalysis (FIM/AP). The as-deposited material was found to contain brightly imaging Cr-rich particles, both spherical and rod-shaped, of about 0.5-lnm in diameter and up to 5nm long. Random area AP analysis showed the presence of Cr-enrichment on a very fine scale, w...
متن کاملTEM INVESTIGATION OF RAPIDLY SOLIDIFIED NDFEB HARD MAGNETIC MATERIAL
The surface condition and microstructure of near stoichiometric (Fe823Ndll.8B5.9) Nd-Fe-B alloy ribbons and the effect of melt spinning parameters were investigated using optical, scanning and transmission electron microscopes (SEM, TEM). The formation of gas pockets on the roll surface of the ribbons during melt spinning can prevent heat transform and result in local coarse grains. The local t...
متن کاملPhase-field simulations of velocity selection in rapidly solidified binary alloys.
Time-dependent simulations of two-dimensional isothermal Ni-Cu dendrites are simulated using a phase-field model solved with a finite-difference adaptive mesh refinement technique. Dendrite tip velocity selection is examined and found to exhibit a transition between two markedly different regimes as undercooling is increased. At low undercooling, the dendrite tip growth rate is consistent with ...
متن کاملGlassy and icosahedral phases in rapidly solidified Ti–Zr–Hf–(Fe, Co or Ni) alloys
The icosahedral quasicrystalline, amorphous plus crystalline and glassy phases were formed in Ti40Zr20Hf20(3d-LTM)20 alloys (3d-LTM=3d late transition metals Fe, Co and Ni). The icosahedral phase formed in the melt-spun Ti40Zr20Hf20Fe20 alloy is metastable and the average size of the quasicrystalline icosahedral particles precipitated in the amorphous matrix is 5 nm. The metastable icosahedral ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2009
ISSN: 1742-6596
DOI: 10.1088/1742-6596/144/1/012105