Digital Multimode Buck Converter Control With Loss-Minimizing Synchronous Rectifier Adaptation
نویسندگان
چکیده
منابع مشابه
A PID Compensator Control for the Synchronous Rectifier Buck DC-DC Converter
This paper aims to design a PID compensator for the control of Synchronous Rectifier (SR) Buck Converter to improve its conversion efficiency under different load conditions. Since the diode rectifier is replaced by a high frequency MOSFET switch, the SR control method itself will be sufficient under heavy load condition, to attain better normal mode performance. However, this technique does no...
متن کاملDigital PWM Control of Synchronous Converter
The proposed system is to utilize the renewable resources by digital PWM control of synchronous converter. Usually PWM pulse is being generated through a digital system such as microcontroller or Digital signal controller. In stand – alone application these controllers increases the cost but XILINX FPGA based PWM generation reduces the cost. XILINX FPGA is invented by XILINX which is being cons...
متن کاملDigital Soft-Start PSM Buck Converter
Although a typical PWM controller is well known for its good regulation capabilities, inrush current and overshoot voltage during start-up period as well as high switching losses at low loads are some of the major factors affecting its otherwise good performance. Therefore in this paper a simple Soft-start pulse skipping modulation (SSPSM) scheme implemented on a typical buck converter is prese...
متن کاملPID Compensator Control Scheme of Synchronous Buck DC-DC Converter with ZVS Logic Circuit
This paper deals with PID compensator control of Synchronous Rectifier (SR) Buck Converter to improve its conversion efficiency under different load conditions with the help of a Zero Voltage Switching(ZVS)Logic Circuit. Since the freewheeling diode is replaced by a high frequency switch MOSFET in this buck configuration, the SR control technique itself will be sufficient under heavy load condi...
متن کاملPV Charger System Using A Synchronous Buck Converter
The paper describes the design, simulation and practical implementation of a PV system specifically designed for battery charging applications. A DC-DC synchronous Buck converter is digitally controlled by a dsPIC33F to extract the maximum power from the PV panel and feed it to the battery, according to the data received through the sensors. The system proves to be stable to rapid weather chang...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Power Electronics
سال: 2006
ISSN: 0885-8993
DOI: 10.1109/tpel.2006.882968