Digital Controller Design Based on Active Damping Method of Capacitor Current Feedback for Auxiliary Resonant Snubber Inverter with LC Filter
نویسندگان
چکیده
منابع مشابه
Stability Improvement of Grid-connected Converter with LCL Filter based on Capacitor Current Active Damping by Computational Delay Reduction
Nowadays, LCL filters utilization to suppress the grid-connected inverter switching harmonics is expanding and various methods such as capacitor current active damping scheme could be investigated to damp out these harmonics. However, the computational delays including control system, and PWM switching delays have significant effect on damping system stability. In most of LCL filter parameter d...
متن کاملA Novel Active Damping Control of a Three-phase PWM Inverter with LC Filter
A novel control method of a three-phase PWM inverter with LC filter is proposed. The transfer function of LC filter is the same as that of 2nd order low pass filter(2nd LPF) which has a zero damping ratio. A simple method of implementing 2nd LPF with damping ratio is to add resistor to inductor or capacitor of LC filter. In an industrial application, it is not practical to adopt damping resisto...
متن کاملHysteresis Current Control with Input Filter Design for High Frequency Series Resonant Full Bridge Inverter
This paper talks about the analysis of a high frequency series resonant inverter for using domestic and industrial induction heating purpose. It is a technique i.e. used for heat conductive materials hard and soft metals. Series Resonant inverters which operate at high frequency preferable for induction heating which normally works in 5-55KHz. High frequency series resonant inverters which is m...
متن کاملThree Level Inverter Based Shunt Active Power Filter Using Multi-Level Hysteresis Band Current Controller
In this paper, a three-level inverter based Shunt Active Power Filter (SAPF) using Multi-Level Hysteresis Current Controller (MLHCC) is presented for solution of power quality problems in distribution system. A simulation model of SAPF is prepared in Matlab/Simulink environment. MLHCC is used for control of SAPF currents. In simulation study, it is considered that SAPF executes two tasks coveri...
متن کاملAnalysis of Input Current Ripple and Optimum Filter Capacitor for Fuel-Cell-Based Single-Phase Inverter
Most single-phase inverters, being sourced by fuel cell stacks (FCSs), subject the stacks to reflected low-frequency (120 Hz) current ripples that ride on average dc currents. The ripple current impacts the sizing and efficiency of the FCS. As such and typically, a passive or active filter is required at the input of the inverter (or output of the FCS) to mitigate the ripple current. Toward tha...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Sciences
سال: 2016
ISSN: 2076-3417
DOI: 10.3390/app6110377