Diagnostic Measurement at Chimney Operation
نویسندگان
چکیده
منابع مشابه
Diagnostic Supports for Top-up Operation at Tls
The routine top-up operation of Taiwan Light Source (TLS) began in October 2005. The beam stability and integrated flux were drastically improved. Various diagnostics are needed to support the top-up operation. These tools include diagnostics for measuring beam charge and current and injection efficiency, as well as a filling pattern monitor, a tune monitor, and an instability and loss pattern ...
متن کاملArchaeological investigations using geophysics at Chimney Rock Great House, Colorado
In this talk, we present results from a geophysical investigation at the Chimney Rock Great House using magnetics, electromagnetics, and DC resistivity. Our data is focused on a grid southwest of the Great House, where we use geophysics to detect potential buried walls. These walls may be covered by 1 to 3 m of fill as a result of nearby excavations in the 1920s, and should be approximately 0.5...
متن کاملThe Beam Instrumentation and Diagnostic Challenges for Lhc Operation at High Energy
This contribution will present the role of beam diagnostics in facing the challenges posed by running the LHC close to its design energy of 7TeV. Machine protection will be ever more critical, with the quench level of the magnets significantly reduced, so relying heavily on the beam loss system, abort gap monitor, interlocks on the beam position and fast beam current change system. Non-invasive...
متن کاملNonlinear Measurement Combinations for Optimal Operation
Competition, rising energy prices and environmental demands make it increasingly necessary to operate chemical processes as close to optimality as possible. In order to avoid suboptimal performance in presence of disturbances, mainly two approaches are considered for control [3]: On-line and off-line optimization based control. The first approach implies computing the optimal setpoints of the c...
متن کاملBasic Solar Chimney Flow Improvements
Preliminary note This paper deals with the numerical analysis procedure and results of flow simulation through solar chimney. Because of relatively low Reynolds numbers, some aerodynamic improvements could be obtained. The paper links input heat energy with geometry or air flow parameters. Basic solar chimney geometry is carried out and analyzed with CFD application in three dimensional domain....
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the VŠB - Technical University of Ostrava, Mechanical Series
سال: 2012
ISSN: 1210-0471,1804-0993
DOI: 10.22223/tr.2012-1/1898