Device with rectangular section for layer-by-layer snow sampling
نویسندگان
چکیده
منابع مشابه
Sensitivity Analysis and Stray Capacitance of Helical Flux Compression Generator with Multi Layer Filamentary Conductor in Rectangular Cross-Section
This paper presents an approach to calculate the equivalent stray capacitance (SC) of n-turn of the helical flux compression generator (HFCG) coil with multi layer conductor wire filaments (MLCWF) in the form of rectangular cross-section. This approach is based on vespiary regular hexagonal (VRH) model. In this method, wire filaments of the generator coil are separated into many very small simi...
متن کاملSnow Crystal Habit Changes Explained by Layer Nucleation
Critical supersaturations have been measured for the vapor growth of ice crystals on both the basal and prism faces between 2168 and 20.48C. The values are low: approximately constant at 0.4% for the prism face, less for the basal face between 238 and 298C, but greater at higher and lower temperatures. The transitions between tabular (platelike) and columnar growth habits that occur near 238 an...
متن کاملBoundary layer physics over snow and ice
Introduction Conclusions References Tables Figures ◭ ◮ ◭ ◮ Back Close Full Screen / Esc Abstract Introduction Conclusions References Tables Figures ◭ ◮ ◭ ◮ Back Close Full Screen / Esc Printer-friendly Version Interactive Discussion EGU Abstract A general understanding of the physics of advection and turbulent mixing within the near surface atmosphere assists the interpretation and predictive p...
متن کاملProtein and Lactose Separation by Modified Ultrafiltration Membrane using Layer by Layer Technique
Layer-by-Layer (LbL) is a method which can be used for nanoscale coating and surface functionalization of a material. LbL technique mainly uses the electrostatic attracting between charged materials (polyelectrolytes, nanoparticles, etc.) and an oppositely charged surface. In this study, protein separation (BSA) from lactose solution was carried out using the LbL self-assembly method, which was...
متن کاملFabrication of Poly(ε-Caprolactone), Hydrophilic and β-Tricalcium Phosphate Layer- by -Layer Nanofibrous Scaffolds for Tissue Engineering
In this study, using biodegradable polymers, nanofiberouse scaffolds were fabricated from the layer-by-layer electrospinning method, including two layer that poly (ε-caprolactone), polyvinylpyrrolidone deposited at first layer and poly (ε-caprolactone), polyvinyl alcohol , β-tricalcium phosphate at latter. After prepration of scaffolds, scanning electron microscopy (SEM), swelling, porosity, me...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Ice and Snow
سال: 2015
ISSN: 2076-6734
DOI: 10.15356/2076-6734-2014-1-81-84