Development of Wideband Spatial Combined High Power Amplifier
نویسندگان
چکیده
منابع مشابه
Broad-Band High-Power Amplifier Using Spatial Power-Combining Technique
High power, broad bandwidth, high linearity, and low noise are among the most important features in amplifier design. The broad-band spatial power-combining technique addresses all these issues by combining the output power of a large quantity of microwave monolithic integrated circuit (MMIC) amplifiers in a broad-band coaxial waveguide environment, while maintaining good linearity and improvin...
متن کاملWideband High Dynamic Range Limiting Amplifier
Many modern EW systems require low noise receivers capable of withstanding wide input power variations over a multioctave bandwidth. These receivers are necessary to protect sensitive components from RF overdrive or to remove AM modulation from incoming signals. Further, multichannel system designs and proximity to the receiver antenna generate requirements for low power and small package size....
متن کاملWideband Low Distortion, High Gain Operational Amplifier
The OPA643 provides a level of speed and dynamic range previously unattainable in a monolithic op amp. Using a de-compensated voltage feedback architecture with two internal gain stages, the OPA643 achieves exceptionally low harmonic distortion over a wide frequency range. The "classic" differential input provides all the familiar benefits of precision op amps, such as bias current cancellation...
متن کاملDesign and development of High Power Ultra Wideband Systems
High power ultra wideband (UWB) systems can be used for various applications like buried target detection, electrical characterization of materials, space debris detection and as a source for vulnerability studies on electronic circuits. Two high power UWB radiator systems have been developed at APPD, BARC Mumbai. The first one is a 120 kV, 66 Ohm system which uses balanced Transverse Electroma...
متن کاملHigh Gain of 3.1-5.1 GHz CMOS Power Amplifier for Direct Sequence Ultra-Wideband Application
This paper presents the design a power amplifier (PA) for direct sequence ultra-wideband applications using 0.13 μm CMOS technology operating in a low band frequency of 3.1 GHz to 5.1 GHz. Current-reused technique is employed at the first stage to increase the gain at the upper end of the desired band. Cascaded common source configuration with shunt peaking inductor at the second stage helps to...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of Korean Institute of Electromagnetic Engineering and Science
سال: 2017
ISSN: 1226-3133,2288-226X
DOI: 10.5515/kjkiees.2017.28.4.286