Development of the Molten Slag Reduction Process -2 Optimization of Slag Reduction Process with Molten Slag Charging
نویسندگان
چکیده
منابع مشابه
Application practice of BOF Slag tailings in steelmaking process
The present paper introduces the steel production and BOF slag processing techniques in Steelmaking Sector of Bayuquan Iron and Steel Subsidiary, Ansteel. The technology of slag tailings utilization has been developed under the consideration of the properties of slag tailing and the characteristics of slag forming in BOF steelmaking operation practice. The processing of the BOF slag includes ho...
متن کاملIN-SITU FABRICATION PROCESS OF AL- TIC COMPOSITE BY SLAG
The new in situ method for AI-TiC composite fabrication has been carried out. In this method, fabrication of AI-TiC composite by simultaneous introduction of titanium oxide and carbon into aluminum melt was investigated.. Under the process conditions, titanium and carbon reaction results in titanium carbide whiskers. The salt containing keriolite (Na3AIF6), titanium oxide (TiO2) and graphite us...
متن کاملSlag Behavior in Gasifiers. Part II: Constitutive Modeling of Slag
The viscosity of slag and the thermal conductivity of ash deposits are among two of the most important constitutive parameters that need to be studied. The accurate formulation or representations of the (transport) properties of coal present a special challenge of modeling efforts in computational fluid dynamics applications. Studies have indicated that slag viscosity must be within a certain r...
متن کاملLinear Collider Development at Slag
The status of the SLC has been described elsewhere in these proceedings.l$* This year’s noteable achievement is an increase of electron beam polarization at the IP from 23% to 63%. Also, luminosity is up from last year, and it is expected that this year’s goal of 50,000 Zs on SLD (Stanford Linear Detector) tape will be achieved. At the end of last year’s run, during E 400 .uncoupled damping rin...
متن کاملElectrochemically Enhanced Reduction of Iron Oxide from Slag
An experimental study was performed to measure the rate of reduction of iron oxide from calcia-silica-alumina slag by carbon in iron, and to determine whether the reaction rate can be increased by electrochemical means. It is shown that the reaction rate depends on both the ferric-ferrous cation ratio, and on the total amount of iron in the slag. It was observed that ferric cations are reduced ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISIJ International
سال: 2018
ISSN: 0915-1559,1347-5460
DOI: 10.2355/isijinternational.isijint-2018-189