Development of Semi-dieless Metal Bellows Forming Process
نویسندگان
چکیده
منابع مشابه
Investigation of hot metal gas forming process of square parts
Aluminum alloys are considered a lot in the automotive and aerospace industry because of their high strength to weight ratio. In this manuscript, the gas forming process of aluminum AA6063 tubes at high temperatures up to 500°C is investigated, through experimental and numerical tests. Therefore, an experimental setup is prepared and so, tube specimens are formed in a die with square cross sect...
متن کاملReliability analysis of the metal forming process
In this paper, we propose a reliability–mechanical study combination for treating the metal forming process. This combination is based on the augmented Lagrangian method for solving the deterministic case and the response surface method. Our goal is the computation of the failure probability of the frictionless contact problem. Normally, contact problems in mechanics are particularly complex an...
متن کاملInvestigation of fluid flow and heat transfer in tube hot metal gas forming process
In this study, hot metal gas forming process of AA6063aluminumtubeis studied with a focus on heat transfer of both fluid and solid phases numerically. An experimental study is simultaneously conducted to validate the numerical method. Some of the most important outputs of the present study, are velocity distribution of fluid inside the tube as well as the fluid in the gap between tube and matri...
متن کاملForming of Multi layer Sheet Metal by Drawing Process: an Analysis and FEM Simulation
In this paper, the drawing process of multi-layer sheet metal through wedge shaped die has been analyzed using stream function and upper bound method. Typically a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and ou...
متن کاملProcess Simulation for Optimizing Superplastic Forming of Sheet Metal
Superplastic forming (SPF) is conducted in a heated, pressurized die where direct monitoring of critical SPF parameters is extremely difficult. Numerical models provide a critical means of tracking the forming process, allowing the applied gas pressure to be adjusted to maintain optimum SPF behavior throughout the forming process. This paper describes how the MARC finite element code was used t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Technology of Plasticity
سال: 2012
ISSN: 0038-1586,1882-0166
DOI: 10.9773/sosei.53.251