Development of self-reinforced low-density polyethylene using γ-irradiation cross-linked polyethylene fibres
نویسندگان
چکیده
منابع مشابه
Grafting of Acrylamide to Low Density Polyethylene During Melt Processing
Acrylamide was grafted in low density polyethylene during melt processing in the presence of a free radical initiator using a torque rheometer in a closed system. Effects of processing time, acrylamide and benzoyl peroxide concentrations were studied. FTIR studies revealed that the degree of grafting increased by an increase in acrylamide concentration. Maximum grafting was obtained at 7 mi...
متن کاملCatalytic conversion of waste low density polyethylene into fuel oil
Waste Low density polyethylenes (LDPE) represent a source of energy and valuablechemicals, were pyrolysed catalytically in a batch reactor under atmospheric pressure. Calciumcarbide was used as a catalyst to explore its effect on pyrolysis product distribution. The effect oftemperature, amount of catalyst and time on the yields of the pyrolysed products wasinvestigated. The effect of catalyst o...
متن کاملOxygen-barrier films based on low-density polyethylene/ ethylene vinyl alcohol/ polyethylene-grafted maleic anhydride compatibilizer
In this research, high oxygen-barrier films were organized based on low-density polyethylene (LDPE)/ ethylene vinyl alcohol (EVOH)/ polyethylene-grafted maleic anhydride (LDPE-g-MA) compatibilizer. The effects of 10–30 wt. % EVOH and 0–10 wt. % LDPE-g-MA loadings on the properties of final films were evaluated. The morphology of specimens was observed by using scanning electron microscopy (SEM)...
متن کاملCross-linked Polyethylene Engineered for TKA
Introduction It is well known that the wear resistance of ultra-high molecular weight polyethylene (UHMWPE) improves in proportion to the crosslinking irradiation dose. It is also well known that the mechanical properties and oxidative stability of UHMWPE are affected by the irradiation dose, resin type, and post-irradiation heat treatment, among others factors. Therefore, careful consideration...
متن کاملSpace Charge Behavior in Low-Density Polyethylene
The space charge distribution in low-density polyethylene (LDPE) was measured with the pulsed electroacoustic (PEA) method. We used three types of LDPE: LDPE-L and LDPE-H were prepared by the high pressure process, and m-LDPE was polymerized with a metallocene catalyst. Space charge in LDPE strongly depended upon the electrode material. Semiconductive electrodes enhanced carrier injection into ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Radiation Physics and Chemistry
سال: 2020
ISSN: 0969-806X
DOI: 10.1016/j.radphyschem.2019.108655