Development of Promising Technology for Manufacturing Parts of Gas Turbine Engines
نویسندگان
چکیده
منابع مشابه
Low Emission Combustion Technology for Stationary Gas Turbine Engines
The need to control exhaust emissions from stationary power sources is dictated by environmental regulations that limit the amount of smoke (particulates), sulfur dioxide, carbon monoxide, hydrocarbons, and oxides of nitrogen or NOx that can be exhausted into the atmosphere. In areas where atmospheric pollution is a serious concern, as in the Los Angeles basin, very low emission levels are dema...
متن کاملVerifiable Control System Development for Gas Turbine Engines
A control software verification framework for gas turbine engines is developed. A stability proof is presented for gain scheduled closed-loop engine system based on global linearization and linear matrix inequality (LMI) techniques. Using convex optimization tools, a single quadratic Lyapunov function is computed for multiple linearizations near equilibrium points of the closed-loop system. Wit...
متن کاملPrognosis of Faults in Gas Turbine Engines
A problem of interest to aircraft engine maintainers is the automatic detection, classification, and prediction (or prognosis) of potential critical component failures in gas turbine engines. Automatic monitoring offers the promise of substantially reducing the cost of repair and replacement of defective parts, and may even result in saving lives. Current processing for prognostic health monito...
متن کاملDesign of Optimum Controllers for Gas Turbine Engines
This paper presents controllers based on linear and nonlinear models of an aircraft gas turbine engine. These models along with the performance indexes, ITAE, IAE and IES are used to estimate the parameters of a PID controller. The parameters and hence the quality of the controllers are very much dependent on the accuracy of the models. It is shown that the Nonlinear AutoRegressive Moving Avera...
متن کاملMillimeter-scale, Mems Gas Turbine Engines
The confluence of market demand for greatly improved compact power sources for portable electronics with the rapidly expanding capability of micromachining technology has made feasible the development of gas turbines in the millimeter-size range. With airfoil spans measured in 100’s of microns rather than meters, these “microengines” have about 1 millionth the air flow of large gas turbines and...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2021
ISSN: 1757-8981,1757-899X
DOI: 10.1088/1757-899x/1079/3/032039