Development of Nanoscale Thermocouple Probes for Local Thermal Measurements
نویسندگان
چکیده
منابع مشابه
Temperature dependence of nanoscale friction investigated with thermal AFM probes
Measurements of nanoscale friction between silicon AFM tips featuring an in-situ solid state heater and silicon substrates (both with native oxide) were performed. The temperature of the heater was varied between room temperature and approximately 650 °C. For these temperatures and the silicon substrate, the temperatures at the point of contact are estimated to range from room temperature to ap...
متن کاملSurface Micromachined Polyimide Scanning Thermocouple Probes
This paper describes micromachined scanning thermocouple probes that exploit the low thermal conductivity and the high mechanical flexibility of polyimide as a structural material. They are surface micromachined using a low-temperature six-mask process suitable for appending to a CMOS fabrication sequence. The probes are 200–1000m long, 40–120m wide, and of varying thickness. They are assembled...
متن کامل[1032] Novel nanoscale method for thermal conductivity measurements
As the downscaling of electronic devices pushes dimensions of its components towards the atomic limits, new measurement tools need to be developed to address new challenges. In particular, nanoscale heat transfer is a key mechanism which is known to limit the performance of nanoscale sized transistors in the processor chips and thus invalidate of a major component Moore’s law of the processor s...
متن کاملNanoscale resolution scanning thermal microscopy using carbon nanotube tipped thermal probes.
We present an experimental proof of concept of scanning thermal nanoprobes that utilize the extreme thermal conductance of carbon nanotubes (CNTs) to channel heat between the probe and the sample. The integration of CNTs into scanning thermal microscopy (SThM) overcomes the main drawbacks of standard SThM probes, where the low thermal conductance of the apex SThM probe is the main limiting fact...
متن کاملTurbulence measurements using a nanoscale thermal anemometry probe
A nanoscale thermal anemometry probe (NSTAP) has been developed to measure velocity fluctuations at ultra-small scales. The sensing element is a free-standing platinum nanoscale wire, 100 nm× 2 μm× 60 μm, suspended between two currentcarrying contacts and the sensor is an order of magnitude smaller than presently available commercial hot wires. The probe is constructed using standard semiconduc...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: e-Journal of Surface Science and Nanotechnology
سال: 2019
ISSN: 1348-0391
DOI: 10.1380/ejssnt.2019.102