Development of Nano-Structured Metals Processed by Severe Plastic Deformation
نویسندگان
چکیده
منابع مشابه
EBSD characterization of nano/ultrafine structured Al/Brass composite produced by severe plastic deformation
In the present work, nano/ultrafine structured Al/Brass composite was produced by accumulative roll bonding (ARB) up to eight cycles. The evolution of grain refinement and deformation texture and their effect on the mechanical properties were investigated. It was observed that by increasing the ARB cycles, due to the difference in flow properties of the metal constituents, brass layers necked, ...
متن کاملZinc based bioalloys processed by severe plastic deformation – A review
Zinc based alloys have recently attracted great attention as promising biodegradable metals. Zinc exhibits moderate degradation rates in biological fluid and the zinc releases during the degradation process is considered safe to human systems. However, these materials exhibit critical limitations in terms of mechanical properties for medical applications. Adding alloying elements as well as gra...
متن کاملNucleation of deformation twins in nanocrystalline face-centered-cubic metals processed by severe plastic deformation
Nanocrystalline nc materials are known to deform via mechanisms not accessible to their coarse-grained counterparts. For example, deformation twins and partial dislocations emitted from grain boundaries have been observed in nc Al and Cu synthesized by severe plastic deformation SPD . This paper further develops an earlier dislocation-based model on the nucleation of deformation twins in nc fac...
متن کاملSevere Plastic Deformation of Metals
This paper provides an introduction in the field of severe plastic deformation (SPD). First of all the main methods to produce SPD materials are discussed. In the following section, the mechanisms leading to the formation of fine grains are reviewed and the influence of changes in strain path is highlighted. During post-SPD thermal annealing, some typical microstructural changes take place. The...
متن کاملParadox of strength and ductility in metals processed by severe plastic deformation
It is well known that plastic deformation induced by conventional forming methods such as rolling, drawing or extrusion can significantly increase the strength of metals However, this increase is usually accompanied by a loss of ductility. For example, Fig. 1 shows that with increasing plastic deformation, the yield strength of Cu and Al monotonically increases while their elongation to failure...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Indian Journal of Science and Technology
سال: 2016
ISSN: 0974-5645,0974-6846
DOI: 10.17485/ijst/2016/v9i27/94379