Development of Na0.5CoO2 Thick Film Prepared by Screen-Printing Process
نویسندگان
چکیده
منابع مشابه
Screen Printing Process Design of Experiments for Fine Line Printing of Thick Film Ceramic Substrates
Screen printing has been the dominant method of thick film deposition because of its low cost. Many experiments in industry have been done and many models of the printing process have been developed since the 1960’s. With a growing need for denser packaging and a drive for higher pin count, screen printing has been refined to yield high resolution prints. However, fine line printing is still co...
متن کاملHumidity sensing properties of a thick - film titania prepared by a slow spinning process
A ceramic thick film humidity sensor was produced from an emulsion of titania powders by a spin coating technique using a low speed. Electrical measurements were taken between interdigital electrodes obtained by depositing silver paste on the oxide, then cured at 500 ◦C for 15 min. Different relative humidities of a dynamic atmosphere were obtained by mixing dry and 23 ◦C saturated synthetic ai...
متن کاملThin Film Solar Cells by Screen Printing Technology
General properties of thin film solar cells and panels are discussed, and compared to crystalline silicon. A state-of-the-art of thin film cells and panels is given. One thin film production technique is elaborated: screen printing and sintering. The technique and its application to CdS/CdTe cells are presented. It is shown that sophistication to the basic technique can overcome inherent shortc...
متن کاملElectrohydrodynamic jet printing of PZT thick film micro-scale structures
Key Laboratory for Micro/Nano Technology and System of Liaoning Province, Dalian University of Technology, Dalian, 116024, China Key Laboratory for Precision and Non-traditional Machining Technology of Ministry of Education, Dalian University of Technology, Dalian, 116024, China College of Electronic Science and Technology, Dalian University of Technology, Dalian, 116024, China Cranfield Univer...
متن کاملThick Film Deposition of Carbon Nanotubes by Alternating Electrophoresis
Electrophoretic deposition of carbon nanotubes (CNTs) using alternating current electric fields (0.01-1000 Hz) is reported. Pure acetone was used as suspending medium. Two parallel gold electrodes were used as depositing substrate. The effect of depositing parameters such as frequency and three waveforms (sinusoidal, rectangular and triangular) on deposit yield was investigated. According to ou...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials
سال: 2020
ISSN: 1996-1944
DOI: 10.3390/ma13122805