Development of High Strength and Toughness Die Steel for Die Casting ‘QDX-HARMOTEX’

Uddeholm Tool Steel for Die Casting

This information is based on our present state of knowledge and is intended to provide general notes on our products and their uses. It should not therefore be construed as a warranty of specific properties of the products described or a warranty for fitness for a particular purpose. Classified according to EU Directive 1999/45/EC For further information see our " Material Safety Data Sheets "....

Computer-Aided System for Multi-Cavity Die-Casting Die-Design

Die-design for the die-casting process is a time consuming and complex activity that requires domain knowledge and vast experience of the die-designer besides information about manufacturing resources, part geometry, delivery time and cost preferences, etc. Complexity of the die-design activity further increases in case of a multi-cavity die. Currently available die-design systems lack in the l...

Die Steels and Improved Productivity in Die Casting

Modern High Pressure Die-casting Processes for Aluminium Castings

There are about 33 processes commercially available for the production of aluminium castings. About 70% of the castings are produced using conventional high-pressure die-casting process. It’s main drawbacks are 1) Air and gas blow holes 2) Unable to weld 3) unable to heat treat to enhance mechanical properties. To overcome these, many modern processes have been invented. A few of them are 1) Hi...

Materials on Dies for Pressure Die Casting

In the contribution the stress of die materials of thermal fatigue is defi ned and material life is derived theoretically and compared with the measured values. The important properties of the die materials as thermal conductivity, coeffi cient of thermal expansivity, modulus of elasticity and mechanical properties are described. Binding to it single die materials as carbon steels and chrome-tu...