Development of Fluctuation Monitor Type Sodium Ionization Detector
نویسندگان
چکیده
منابع مشابه
Calorimetric Ionization Detector
A new mode of operation for ionization detectors is described. The amount of ionization produced in a detector is detennined by measuring the amount of heat generated during the carrier collection process. Very high detection sensitivities, including single carrier detection, may be achieved at cryogenic temperatures. Results from an experimental device operated at T=O.3K is presented.
متن کاملA Prototype Ionization Profile Monitor for Rhic
Transverse beam profiles in the Relativistic Heavy-Ion Collider (RHIC) will be measured with ionization profile monitors (IPM’s). Each IPM collects and measures the distribution of electrons in the beamline resulting from residual gas ionization during bunch passage. The electrons are swept transversely from the beamline and collected on strip anodes oriented parallel to the beam axis. At each ...
متن کاملDissolution and ionization of sodium superoxide in sodium–oxygen batteries
With the demand for high-energy-storage devices, the rechargeable metal-oxygen battery has attracted attention recently. Sodium-oxygen batteries have been regarded as the most promising candidates because of their lower-charge overpotential compared with that of lithium-oxygen system. However, conflicting observations with different discharge products have inhibited the understanding of precise...
متن کاملDevelopment of Pair Monitor
Figure 1: A schematic view of the forward region. The pair monitor will be located in front of the BeamCal, where is about 400 cm from IP. At ILC, measurement of the beam profile at IP is important to keep high luminosity of 2 × 10 cms. The beam size at IP is 639 nm, 5.7 nm, and 300 μm for horizontal (σX), vertical (σY), and longitudinal beam size (σZ), respectively. Since the beam size, especi...
متن کاملBench Test of a Residual Gas Ionization Profile Monitor (RGIPM)
An RGIPM has been designed, constructed and bench tested to verify that all components are functioning properly and that the desired resolution of about 50 μm rms can be achieved. This paper will describe major considerations that went into the bench test and some results.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Nuclear Science and Technology
سال: 1986
ISSN: 0022-3131,1881-1248
DOI: 10.1080/18811248.1986.9735025