Development of fiber reineforced aluminum connecting rod.
نویسندگان
چکیده
منابع مشابه
Process-based tolerance assessment of connecting rod machining process
Process tolerancing based on the process capability studies is the optimistic and pragmatic approach of determining the manufacturing process tolerances. On adopting the define–measure–analyze–improve–control approach, the process potential capability index (C p) and the process performance capability index (C pk) values of identified process characteristics of connecting rod ...
متن کاملProcess capability improvement of an engine connecting rod machining process
Statistical process control is an excellent quality assurance tool to improve the quality of manufacture and ultimately scores on end-customer satisfaction. SPC uses process monitoring charts to record the key quality characteristics (KQCs) of the component in manufacture. This paper elaborates on one such KQC of the manufacturing of a connecting rod of an internal combustion engine. Here th...
متن کاملConnecting Rod Evaluation
Since 1986, more than 500 million powder forged (PF) connecting rods have been manufactured and installed in automobiles worldwide. The application of forging a preformed near-net shape consolidated from metal powder has been widely accepted since the early eighties and today is the preferred manufacturing technique for 60% of the connecting rods manufactured in North America. The remaining por...
متن کاملFinite Element Analysis of Connecting Rod
Abstract—The connecting rod transmits the piston load to the crank causing the latter to turn, thus converting the reciprocating motion of the piston into a rotary motion of the crankshaft. Connecting rods are subjected to forces generated by mass and fuel combustion. This study investigates and compares the fatigue behavior of forged steel, powder forged and ASTM a 514 steel cold quenched conn...
متن کاملStudy and Simulation of Shot peening Effect on Fatigue Life of a Powder Forged Connecting rod
Shot peening applies a residual compressive stress field (RCSF) on the surface of parts. It also shifts “crack nucleation sites” to sub-surface locations. A nondestructive method of measuring the stresses, Sin2ψ was utilized here and the stress values introduced to Ansys software. For this purpose, uniform stress in all directions was applied on the con rod. Loading on the rod in Ansys had thre...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of the Japan Institute of Metals
سال: 1986
ISSN: 0021-4426,1884-5835
DOI: 10.2320/materia1962.25.565