Development of E-100 Fuel Pump Lower Housing Using Cold Forging Process
نویسندگان
چکیده
منابع مشابه
Optimization of Flash, Billet Dimensions and Friction Factor in Closed Die Cold Forging Process
Three important parameters in designing a closed die for forging process are ratio of width to flash thickness, ratio of height to billet diameter and the friction factor. In this paper the influences of these parameters on the required force for the forging and percentage of die filling were investigated. It was found that by controlling the flash dimension, the material loss is reduced and t...
متن کاملPrediction of Residual Stresses for a Hollow Product in Cold Radial Forging Process
Radial forging is an open die forging process used for reducing the diameters of shafts, tubes, stepped shafts and axles and also for creating internal profiles such as rifling the gun barrels. The radial forging of tube is usually performed over a mandrel to create an internal profile and/or size the internal diameter. Most of the previous studies conducted on the radial forging process have u...
متن کاملDevelopment of Air Pump for Fuel Cells
In recent years, as the mobile equipment advances, higher output and higher energy density are required of the battery which drives the mobile equipment. As one of the solutions, development of portable fuel cells (DMFC) with methanol used for fuel has been progressed and the fuel cells will be soon put to practical use. The authors have developed a small air pump (0.2W output), which is mounte...
متن کاملSimulation of Cold Rolling Process Using Smoothed Particle Hydrodynamics (SPH)
Regarding the reported capabilities and the simplifications of the smoothed particle hydrodynamics (SPH) method, as a mesh-free technique in numerical simulations of the deformation processes, a 2-D approach on cold rolling process was provided. Using and examining SPH on rolling process not only caused some minor developments on SPH techniques but revealed some physical realities. The chosen t...
متن کاملNumerical Simulation of Forging Process Using the Hybrid PCM/FEM
In this paper, for analyses of metal forming problems, a point collocation method (PCM) with a boundary layer of finite element is developed. PCMs have some advantages such as no mesh, no integration. While, the robustness of the PCMs is an issue especially when scattered and random points are used. To improve the robustness, some studies suggest that the positivity conditions can be important ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Korea Academia-Industrial cooperation Society
سال: 2012
ISSN: 1975-4701
DOI: 10.5762/kais.2012.13.1.14