Development of Composite Abrasives Considering Stagnation of Abrasives and Their Polishing Characteristics
نویسندگان
چکیده
منابع مشابه
Parametric analysis of Abrasives water jet machining of EN8 Material
Abrasive water jet machine (AWJM) is a mechanical base non-conventional machining process. This is process of removal of materials by impact erosion of high pressure (1500-4000 bar), high velocity of water and entrained high velocity of grit abrasives on a work piece. Experimental investigations were conducted to assess the influence of abrasive water jet machining (AWJM) process parameters on ...
متن کاملWear of composites by abrasives of varying hardness.
The relationship between the wear of three composite resins and the hardness of the abrasive was studied by a two-body abrasion test. The wear rates of the composites increased linearly with abrasive hardness from 530 to 2080 KHN. Measurement of the slope of the wear rate versus abrasive hardness over this range provided a sensitive method for ranking the composites.
متن کاملarchitecture and engineering of nanoscale sculptured thin films and determination of their properties
چکیده ندارد.
15 صفحه اولMechanical Removal in CMP of Copper Using Alumina Abrasives
Results from experiments on the removal of copper using chemical mechanical polishing ~CMP! by alumina abrasives suspended in deionized water are reported. The experiments were carried out in a benchtop polishing tool using IC1000 perforated pads and SUBA 500 pads. The removal rate was measured over a good range of values of the relative velocity and pressure, and for different values of the ab...
متن کاملDevelopment of a Lapping Film Utilizing Agglomerative Fine Abrasives for Finishing of Optical Glass
In the finishing process of optical glass, polishing with ceria, silica or zirconia slurry is conventionally adopted. The machining process, however, has problems involving inefficiency and a detrimental impact on the environment. Therefore, it is strongly recommended that the process be replaced with fixed-abrasive machining, but conventional fixed-abrasive tools have problems relating to low ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 2012
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.78.2302