Development of Ceramic Shaping Device with Electrophoretic Deposition Method.
نویسندگان
چکیده
منابع مشابه
Electrophoretic Deposition of Hydroxyapatite
The purpose of this study was to investigate the deposition of the hydroxyapatite (HA) coating via the electrophoresis procedure. The HA deposition was performed in an ethanol, methanol, acetone and isopropanol suspension. Methanol was found to be the best deposition media. Among the different environmental conditions, including the encapsulation of the samples under two vacuum types of pr...
متن کاملAffectability of ceramic nanoparticles of different compound from surface characteristics in AC electrophoretic deposition
Surface characteristic of particles is one of the main parameters controlling the properties of deposited layer in electrophoretic deposition. To modify the surface characteristic of particles, one of the methods is the addition of additives to the suspensions of powder-solvent. There are many reports dealing with the effect of surface characteristics of particles on uniformity and pattern of d...
متن کاملelectrophoretic deposition of hydroxyapatite
the purpose of this study was to investigate the deposition of the hydroxyapatite (ha) coating via the electrophoresis procedure. the ha deposition was performed in an ethanol, methanol, acetone and isopropanol suspension. methanol was found to be the best deposition media. among the different environmental conditions, including the encapsulation of the samples under two vacuum types of pressur...
متن کاملElectrophoretic deposition of biomaterials.
Electrophoretic deposition (EPD) is attracting increasing attention as an effective technique for the processing of biomaterials, specifically bioactive coatings and biomedical nanostructures. The well-known advantages of EPD for the production of a wide range of microstructures and nanostructures as well as unique and complex material combinations are being exploited, starting from well-disper...
متن کاملElectrophoretic Deposition of Gallium with High Deposition Rate
In this work, electrophoretic deposition (EPD) is reported to form gallium thin film with high deposition rate and low cost while avoiding the highly toxic chemicals typically used in electroplating. A maximum deposition rate of ~0.6 μm/min, almost one order of magnitude higher than the typical value reported for electroplating, is obtained when employing a set of proper deposition parameters. ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Powder Technology, Japan
سال: 2001
ISSN: 0386-6157,1883-7239
DOI: 10.4164/sptj.38.633