Development of Ceramic Cutting Tools for Future Application on Dry Machining
نویسندگان
چکیده
منابع مشابه
application of upfc based on svpwm for power quality improvement
در سالهای اخیر،اختلالات کیفیت توان مهمترین موضوع می باشد که محققان زیادی را برای پیدا کردن راه حلی برای حل آن علاقه مند ساخته است.امروزه کیفیت توان در سیستم قدرت برای مراکز صنعتی،تجاری وکاربردهای بیمارستانی مسئله مهمی می باشد.مشکل ولتاژمثل شرایط افت ولتاژواضافه جریان ناشی از اتصال کوتاه مدار یا وقوع خطا در سیستم بیشتر مورد توجه می باشد. برای مطالعه افت ولتاژ واضافه جریان،محققان زیادی کار کرده ...
15 صفحه اولThe Effects of ZrO2 or Tic on the Performance of the Alumina-Based Ceramic Cutting Tools
Two types of alumina-based cutting tools with compositions of 90 vol.% Al2O3+10 vol.% ZrO2 and 80 vol.% A12O3+20 vol.% TiC are produced by isostatic pressing and sintering technique. The effects of these additives on the mechanical properties and cutting performance of these materials are investigated. The tool life in both materials is examined under identical conditions on cutting a grey cast...
متن کاملApplication of Ultrasonic Assisted Machining Technique for Glass-Ceramic Milling
In this study, ultrasonic assisted machining (UAM) technique is applied in side-surface milling experiment for glass-ceramic workpiece material. The tungsten carbide cutting-tool with diamond coating is used in conjunction with two kinds of cooling/lubrication mediums such as water-soluble (WS) cutting fluid and minimum quantity lubricant (MQL). Full factorial process parameter combinations on ...
متن کاملResearch on Cutting Performance of Ceramic Cutting Tools in Milling High Density Fiberboard
The effect of cutting parameters and tool parameters on cutting forces and tool wear were investigated in high density fiberboard (HDF) peripheral up-milling using toughened ceramic cutting tools. The results showed that whether at low speed cutting or high speed cutting, the tangential forces Ft and normal forces Fr increased slowly with the increase of cutting length. The tangential forces Ft...
متن کاملThe Orthogonal Machining Process Using Cutting Tools with Different Geometry
This paper deals with modelling of the orthogonal machining process using tools with different geometries. The finite element method (FEM) is used for a simulation based on the Lagrangian formulation including ANSYS/LS-DYNA software. The constitutive Johnson – Cook material model regarding strain, strain rate and temperature to predict material plasticity and chip separation is used. Chip morph...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Science Forum
سال: 2010
ISSN: 1662-9752
DOI: 10.4028/www.scientific.net/msf.660-661.724