Development in Water-Borne Heavy Duty Coating System
نویسندگان
چکیده
منابع مشابه
Shift Control System of Heavy-duty Vehicle Automatic Transmission
Heavy-duty vehicle hydrodynamic mechanical automatic transmission shifting operation system was designed, mathematical model of its simplified hydraulic system was established and simulation model of shifting operation system was established with AMESim, the simulation experiment was carried out, then oil pressure curves of each clutch hydraulic cylinder were obtained when giving forward gear o...
متن کاملOn-road heavy-duty vehicle emissions monitoring system.
The introduction of particulate and oxides of nitrogen (NOx) after-treatment controls on heavy-duty vehicles has spurred the need for fleet emissions data to monitor their reliability and effectiveness. The University of Denver has developed a new method for rapidly measuring heavy-duty vehicles for gaseous and particulate fuel specific emissions. The method was recently used to collect 3088 me...
متن کاملDecentralized Diagnosis in Heavy Duty Vehicles
Fault diagnosis is important for automotive vehicles, due to economic reasons, such as efficient repair and fault prevention, and legislative reasons, mainly safety and pollution. Embedded systems in vehicles includes a large number of electronic control units, that is connected to each other via an electronic network. Many of the current diagnostic systems use pre-compiled diagnostic tests, an...
متن کاملAir Leakage Diagnosis in Heavy Duty Truck
Sammanfattning Scania CV AB is a leading company within development and production of buses, trucks as well as industrial and marine engines. New environmental and safety legislations continuously demand higher quality from the products. An upcoming European legislation, Euro 6, implies that gas leakages from truck engines should be detected while driving. If the source of the leakage is not on...
متن کاملSelective Catalytic Reduction for Heavy-duty and Light-duty Vehicles
Whereas previous emission limit values could be met by primary engine control measures, the limits for PM and NOx from heavy duty engines in 2008/09 (Euro V) and diesel passenger cars in 2014/15 (Euro 6) represent a challenge for the developers of diesel engines and vehicles. Due to the thermodynamics of the Diesel combustion process, it is difficult to optimise the combustion process for both ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of The Surface Finishing Society of Japan
سال: 2013
ISSN: 0915-1869,1884-3409
DOI: 10.4139/sfj.64.168