Development and Verification of Motor Load Test Equipment Using Disk Brake
نویسندگان
چکیده
منابع مشابه
Automatic Load Test Verification Using Control Charts
Load testing is an important phase in the software development process. It is very time consuming but there is usually little time for it. As a solution to the tight testing schedule, software companies automate their testing procedures. However, existing automation only reduces the time required to run load tests. The analysis of the test results is still performed manually. A typical load tes...
متن کاملautomatic verification of authentication protocols using genetic programming
implicit and unobserved errors and vulnerabilities issues usually arise in cryptographic protocols and especially in authentication protocols. this may enable an attacker to make serious damages to the desired system, such as having the access to or changing secret documents, interfering in bank transactions, having access to users’ accounts, or may be having the control all over the syste...
15 صفحه اولdevelopment of different optical methods for determination of glucose using cadmium telluride quantum dots and silver nanoparticles
a simple, rapid and low-cost scanner spectroscopy method for the glucose determination by utilizing glucose oxidase and cdte/tga quantum dots as chromoionophore has been described. the detection was based on the combination of the glucose enzymatic reaction and the quenching effect of h2o2 on the cdte quantum dots (qds) photoluminescence.in this study glucose was determined by utilizing glucose...
Modelling and Test Verification of Suspension Optimal Damping Ratio for Electric Vehicles Considering Occupant-cushion and In-wheel Motor Effects
The damping ratio of chassis suspension is a key parameter for damping matching of in-wheel motor vehicles (IWMVs). Because the motor is attached to the driving wheel, the initial design method of the damping ratio for traditional cars is not entirely suitable for IWMVs. This paper proposes an innovative initial design method of the damping ratio for IWMVs. Firstly, a traveling vibration model ...
متن کاملDisk brake squeal prediction using the ABLE algorithm
Disk brake squeal noise is mainly due to unstable friction-induced vibration. A typical disk brake system includes two pads, a rotor, a caliper and a piston. In order to predict if a disk brake system will generate squeal, the finite element method (FEM) is used to simulate the system. At the contact interfaces between the pads and the rotor, the normal displacement is continuous and Coulomb’s ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Power Electronics
سال: 2014
ISSN: 1348-8538,1884-3239
DOI: 10.5416/jipe.40.128