Development and Performance Analysis of a New Self-Powered Magnetorheological Damper with Energy-Harvesting Capability

نویسندگان

چکیده

Magnetorheological (MR) dampers, used as intelligent semi-active vibration control devices to achieve low energy consumption, fast response, controllability, and other capabilities are generally installed with a variety of sensors on their exterior ensure that the damping force can be accurately controlled. However, external often affected by complications reduce reliability damper, cost powering damper coils in remote locations where power is not available significantly increased. Based these problems, new self-powered MR scheme proposed. The proposed has both energy-harvesting greatly improves stability application range device converting into electrical supply excitation coil. drive piston rod linear reciprocating motion excitation, which converts mechanical via DC brushless three-phase generator after conversion double-linkage mechanism. At same time, generated passed coil change output damper. Meanwhile, performance efficiency experimentally tested. Experimental results show reaches 1040 N when applied current 0.6 A. an instantaneous voltage amplitude 1.782 V peak phase 4.428 W input 12.5 mm frequency 3 Hz.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Development of a Self-Powered Magnetorheological Damper System for Cable Vibration Control

A new self-powered magnetorheological (MR) damper control system was developed to mitigate cable vibration. The power source of the MR damper is directly harvested from vibration energy through a rotary permanent magnet direct current (DC) generator. The generator itself can also serve as an electromagnetic damper. The proposed smart passive system also incorporates a roller chain and sprocket,...

متن کامل

Energy Harvesting for Self-Powered Nanosystems

Address correspondence to [email protected] ABSTRACT In this article, an introduction is presented about the energy harvesting technologies that have potential for powering nanosystems. Our discussion mainly focuses on the approaches other than the well-known solar cell and thermoelectrics. We mainly introduce the piezoelectric nanogenerators developed using aligned ZnO nanowire arrays. This is...

متن کامل

Fully Self-Powered Electromagnetic Energy Harvesting System

This paper describes the use of piezoelectric polymers in order to harvest energy from people walking, together with the electronics needed to increase energy transfer and storage efficiency. An electrostatic generator was also included in order to increase energy harvesting. There have been independent solutions in increasing the harvesting efficiency either on the mechanical harvester or on i...

متن کامل

Energy Harvesting for Self Powered Sensor Systems

Wireless autonomous sensor systems become steadily standard components in our environment and they become smaller, cheaper and more sophisticated. Energy harvesters fabricated by micro-system technology can realize the autonomy of those systems. An overview of latest results and remaining challenges will be given with the focus on vibration energy harvesters. These harvesters are of specific in...

متن کامل

Design and Evaluation of a Magnetorheological Damper Based Prosthetic Knee

In this work, a magnetorheological (MR) damper based above-knee prosthesis is design and evaluated based on its performance in swing phase and in stance phase. Initially, a dynamic system model for swing phase of a prosthetic leg incorporating a single-axis knee with ideal MR damper was built. The dynamic properties of the damper are represented with Bingham parametric model. From Bingham model...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Energies

سال: 2021

ISSN: ['1996-1073']

DOI: https://doi.org/10.3390/en14196166