Detonation Self-Lubricating Antifriction Glass Composition

نویسندگان

چکیده

Antifriction self-lubricating glass composite coatings of the Sic-Ni-Cu-Al-Si-C type additionally contain an aluminoborosilicate phase and structurally free MgC2, which forms α-graphite during thermolysis, synergistic effect causes modification friction surface due to formation antifriction layer. The influence structural components coating on their contribution properties is considered. It was clarified that increase in adhesive strength achieved by preliminary application a sublayer vitreous sodium silicate. developed showed high performance properties, while means minimizing stabilizing wear characteristics presence thin-film layer based α-graphite, shields unacceptable processes molecular-adhesive interaction.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Self-Organization during Friction of Slide Bearing Antifriction Materials

This article discusses the peculiarities of self-organization behavior and formation of dissipative structures during friction of antifriction alloys for slide bearings against a steel counterbody. It shows that during self-organization, the moment of friction in a tribosystem may be decreasing with the load growth and in the bifurcations of the coefficient of friction with respect to load. Sel...

متن کامل

Dissolution of composition B detonation residuals.

Composition B (Comp B) detonation residuals pose environmental concern to the U.S. Army because hexahydro-1,3,5-trinitro-1,3,5-triazine (RDX), a constituent, has contaminated groundwater near training ranges. To mimic their dissolution on surface soils, we dripped water at 0.51 ml/h onto individual Comp B particles (0.1-2.0 mg) collected from the detonation of 81-mm mortars. Analyses of the eff...

متن کامل

CrN–Ag self-lubricating hard coatings

CrN–Ag composite films, 2.5–4 Am thick, were deposited by reactive magnetron sputtering on Si and stainless steel substrates in a 0.4 Pa pure nitrogen atmosphere at 500 -C. The layer composition was controlled by the relative power to 7.5-cm-diameter Ag and Cr targets to be 0, 3, 12, and 22 at.% Ag. The layers exhibit a dense columnar microstructure where the Ag is homogeneously distributed in ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Nanomaterials

سال: 2022

ISSN: ['1687-4110', '1687-4129']

DOI: https://doi.org/10.1155/2022/1493066