Determining the Optimum Total Solid Yield of Hydrothermal Waste Processing Products Through Mechanical Drying
نویسندگان
چکیده
منابع مشابه
Hydrothermal Treatment of Municipal Solid Waste to Produce Solid Fuel
This paper describes the application of innovative hydrothermal technology on local municipal solid waste (MSW) to produce low chlorine content solid co-firing fuel with coal. Raw MSW was treated at temperatures ranging from 210 to 235°C with 30 to 90 minutes holding period. The process yielded slump products which were then naturally dried to 5% moisture content, resulted in dry products with ...
متن کاملAutothermal Drying of Organic Fraction of Municipal Solid Waste
In order to take advantage of heat released during composting, the autothermal drying process requires the maintenance of adequate air flow combined with temperature. The aim of this paper was to construct a drying tunnel enabling the automatic control and regulation of the basic process parameters for biomass drying (organic fraction of municipal solid waste together with plant structural mate...
متن کاملComplexity in Solid Waste Processing
Automated solid waste processing is a very compli cated task: complicated equipment should be consid ered despite the fact that it can cause inordinate downtime if misapplied. Examples from laboratory re search and development are compared with reports of �eld experience to produce guidelines for distinguish mg between the types of equipment complexity that are and are not acceptable. A ren...
متن کاملMunicipal Solid Waste Composting: Biological Processing
composting process, as one or the other is normally a limiting factor. Carbon serves primarily as an energy source for the microorganisms, while a small fraction of the carbon is incorporated in their cells. Nitrogen is critical for microbial population growth, as it is a constituent of protein which forms over 50 percent of dry bacterial cell mass. If nitrogen is limiting, microbial population...
متن کاملMetal partitioning in products of incineration of municipal solid waste.
Metals contained in the waste transfer to the waste incineration products, including flue gas, fly ash, and bottom ash, as different oxide, nitride, carbides, and other phases. Most of the metal-based phases formed in incineration are toxic and their emissions need to be strictly controlled. Therefore, behavior of metal species during incineration must be well understood. Such understanding is ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: E3S Web of Conferences
سال: 2018
ISSN: 2267-1242
DOI: 10.1051/e3sconf/20186702036