Determining optimum inertial measurement unit architecture from the view-point of sensor fault detection
نویسندگان
چکیده
منابع مشابه
Study of Inertial Measurement Unit Sensor
This paper contains the study about the inertial measurement unit (IMU) sensor. The study is about the types available in markets and also some research on IMU. In this paper also included the uncertainty of some IMU been used and comparison between some IMU manufacturers. Then the combination of IMU with GPS can provide more effective result for navigation, guidance and controlling system for ...
متن کاملInertial Measurement Unit Simulator
During the last few years microminiaturized inertial sensors were introduced in many applications. Their small size, low power consumption, rugged construction open doors to many areas of implementation. The main drawback of these sensors is the influence of different type of errors, leading to an unavoidable wrong position and orientation estimation. In the paper a simulator of Inertial Measur...
متن کاملPre-impact fall detection using an inertial sensor unit
Falls are a major cause of injuries and deaths in older adults [1]. As for intervention strategies, one of the important problems in preventing or reducing the severity of injury in the elderly is to detect falls in its descending phase before the impact [2]. If a fall can be detected in its earliest stage in the descending phase, more efficient impact reduction systems can be implemented with ...
متن کاملSensor Location Based Optimum Design for Fault Detection System
This paper addresses the optimum design of fault detection systems based on sensor location. A multi-objective optimization problem based on optimal sensor location for fault detection is formulated for linear time invariant system. Measurement outputs are formed by selecting m variables of N available process measurements that ensures a high fault detetion performance. A minimum total measurem...
متن کاملInertial Measurement Unit Calibration Platform
The Department of Mechanical Engineering and Avionics Engineering Center at Ohio University are developing an electromechanical system for the calibration of an inertial measurement unit (IMU) using global positioning system (GPS) antennas. The GPS antennas and IMU are mounted to a common platform to be oriented in the angular roll, pitch, and yaw motions. Vertical motion is also included to te...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Vojnotehnicki glasnik
سال: 2004
ISSN: 0042-8469
DOI: 10.5937/vojtehg0402147j