Determining Main Reliability Parameters for Semiconductor Foundry CMOS Process
نویسندگان
چکیده
منابع مشابه
Triaxial Monolithic Piezoresistive Accelerometers in Foundry CMOS
1996 ii The thesis of Brett Alan Warneke is approved. Figure 3-7 Cross-sectional diagram of an aluminum trace running between oxide plates and contacting a polysilicon piezoresistor. The oxide and first metal overetch into the silicon substrate causes the trace Figure 3-8 SEM of a Skeleton Crew accelerometer with bond wires providing 9.6 µgm of additional proof mass. The plate has been bent up ...
متن کاملVolatile Organic Compounds Monitoring for Semiconductor Foundry Clean Room Air
Air samples were collected in consecutive days using Summa canisters from semiconductor foundry clean rooms and air entrances. By coupling a NuTech preconcentrator with an Agilent GC-MS, an optimized method for qualitative and quantitative analysis of VOC compounds was developed. Method detection limit (MDL), blank spike (BS) and blank spike duplicate (BSD), etc. were estimated for method valid...
متن کاملIntegration of solid-state nanopores in a 0.5 μm CMOS foundry process.
High-bandwidth and low-noise nanopore sensor and detection electronics are crucial in achieving single-DNA-base resolution. A potential way to accomplish this goal is to integrate solid-state nanopores within a CMOS platform, in close proximity to the biasing electrodes and custom-designed amplifier electronics. Here we report the integration of solid-state nanopore devices in a commercial comp...
متن کاملStructural similarity image quality reliability: Determining parameters and window size
The need to obtain objective values of the quality of distorted images with respect to the original is fundamental in multimedia and image processing applications. It is generally required that this value correlates well with the human vision system (HVS). In spite of the properties and the general use of themean square error (MSE) measurement, this has a poor correlation with HSV, which has le...
متن کاملDetermining the Optimum Process Parameters by Asymmetric Quality Loss Function
Huang presented a trade-off problem, taking both product quality and process adjustment cost into account, to determine the optimum parameters (i.e., the process mean and process variance) of the input characteristic in the transformation model. In Huang’s transformation model, the input characteristic, x, is assumed to be normally distributed and the output characteristic, y, is nominal-the-be...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nanoindustry Russia
سال: 2018
ISSN: 1993-8578
DOI: 10.22184/1993-8578.2018.82.257.263