Determination of Size Distribution and Probable Maximum Size of Inclusions in AISI304 Stainless Steel
نویسندگان
چکیده
منابع مشابه
language learning strategies and vocabulary size of iranian efl learners
learning a second or foreign language requires the manipulation of four main skills, namely, listening, reading, speaking, and writing which lead to effective communication. it is obvious that vocabulary is an indispensible part of any communication, so without a vocabulary, no meaningful communication can take place and meaningful communication relies heavily on vocabulary. one fundamental fac...
Estimation of Maximum Inclusion Size and Fatigue Limit in HSLA-100 Steel
The objective of the current study is to determine the fatigue limit of a clean and high-performance material named as HSLA-100 steel and to compare the obtained fatigue limit with that of theoretically predicted fatigue limit by statistics of extreme value (SEV) method. Also, the size of inclusions located at the site of fatigue crack nucleation on the fracture surface of the fatigue test spec...
متن کاملCorrosion at Sulphide Inclusions in Stainless Steel
Auger analysis was performed using a high resolution scanning auger electron microscope and auger electron spectroscopy. Elemental auger contour maps for corroded sulphide inclusions in stainless steel were presented. It was found that the copper enriched-manganese sulphide inclusions were uniformly corroded, which might be due to CU2S deposition on the surface of corroding inclusions. In contr...
متن کاملThe Effect of Hot Deformation Parameters on Grain Size Refinement in a Martensitic Stainless Steel
The grain size refinement of AISI 422 martensitic stainless steel in the temperature range of 950-1150 ºC was investigated by hot deformation tests. The deformed specimens were held at deformation temperature with delay times of 5 to 300s after achieving a strain of 0.3. The austenite grains exhibit a considerable growth at temperature higher than 1050˚C, while the grain coarsening is negligibl...
متن کاملCompressibility and Foaming behavior of steel slag/waste glass compositesby particle size distribution and foam agents
In present research, the foam glass-ceramic composites fabricated by window glass, steel slag and SiC, CaCO3 foaming agents were investigated by press–sintering method. The optimum sintering temperature was obtained at 1200°C with a 3-minutes holding time and 20°C/min heating rate. The optimum pressure level of 80 MPa for achieving the 70 % of relative density was selected. The effec...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISIJ International
سال: 2013
ISSN: 0915-1559,1347-5460
DOI: 10.2355/isijinternational.53.1968