Determination of radioactive tellurium in fission products (I)
نویسندگان
چکیده
منابع مشابه
Transmutation of Fission Products
Studies of transmutation of long-lived fission products by accelerator and by fission reactor at PNC are described. Four transmutation methods by accelerators are compared in terms of transmutation energy and transmutation rate. A super-powered electron linear accelerator which could transmute a large quantity of fission products has been studied and development of PNC test linac in this line i...
متن کاملCatalytic Spectrophotometric Determination of Traces of Tellurium (IV)
A Simple, rapid and sensitive method has been developed for determination of trances of tellurium (VI) (0.096-1.250 mg/mL) based on its catalytic effect on the reduction reaction of toluidine blue by sulfide ion at pH 4. The reaction is monitored spectrophotometrically by measuring the decrease in absorbance of the dyestuff at 628 nm by the fixed time method. The detection...
متن کاملdetermination of maximal singularity free zones in the workspace of parallel manipulator
due to the limiting workspace of parallel manipulator and regarding to finding the trajectory planning of singularity free at workspace is difficult, so finding a best solution that can develop a technique to determine the singularity-free zones in the workspace of parallel manipulators is highly important. in this thesis a simple and new technique are presented to determine the maximal singula...
15 صفحه اولFission of Radioactive Beams and Dissipation in Nuclear Matter*
The use of radioactive beams in inverse kinematics dramatically increased the number of isotopes which can be studied at excitation energies ranging from a few to several hundred MeV. Since this method is not subject to target restrictions, long isotopic and isotonic chains could be investigated, and hence, studies of the evolution of fission fragment charge yields, of total kinetic energies, a...
متن کاملChapter 3 Solution of Fission Products in
UO2 is the standard nuclear fuel used in modern, conventional power reactors (e.g. PWR, BWR and AGR). The oxide phase of fissile uranium provides the necessary thermodynamic stability required in operating conditions. It then follows that an extensive knowledge of the properties of this material is necessary. Unfortunately, experimental research is costly, especially if fission products are con...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: BUNSEKI KAGAKU
سال: 1960
ISSN: 0525-1931
DOI: 10.2116/bunsekikagaku.9.584