Determination of Optimum Forming Path in Three-Roll Bending by Controlled FEM Simulation.
نویسندگان
چکیده
منابع مشابه
Forming of Multi layer Sheet Metal by Drawing Process: an Analysis and FEM Simulation
In this paper, the drawing process of multi-layer sheet metal through wedge shaped die has been analyzed using stream function and upper bound method. Typically a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and ou...
متن کاملDetermination of Buckling Limit of Strain in Cold Roll Forming through Finite Element Analysis
In this study, "Buckling Limit of Strain" (B.L.S.) is introduced as one of the most important limiting factors in cold roll forming process. B.L.S. is calculated by the finite element procedure. Then for two particular processes with existing analysis and experimental results, B.L.S. has been determined and evaluated. LUSAS 12.3 is used for finite element analysis. The results show that when bu...
متن کاملDetermination of Buckling Limit of Strain in Cold Roll Forming through Finite Element Analysis
In this study, Buckling Limit of Strain (B.L.S.) is introduced as one of the most important limiting factors in cold roll forming process. B.L.S. is calculated by the finite element procedure. Then for two particular processes with existing analysis and experimental results, B.L.S. has been determined and evaluated. LUSAS 12.3 is used for finite element analysis. The results show that when buck...
متن کاملFEM Simulation of the stretch-forming of aircraft skins
The principle of this process is shown in Figure 1. Only one die (the stretch-block) is needed, which contains the shape of the part. The sheet, clamped with two gripper jaws, is formed around the stretch-block, when the grippers move along the given trajectories. Accurately shaped products can be obtained with minimal springback, when stretch deformation is added to the bending deformation of ...
متن کاملModelling and Simulation of the Roll Forming Process
Cold roll forming (CRF) is a bending process where the bending occurs gradually in severalforming steps from an undeformed strip to a finished profile. The process is very interesting for thesheet metal industry due to the high speed in which the profile can be produced. High strength steelhas, in recent years, become more common in CRF. These materials have advantages but also<...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1994
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.60.3963