Deterioration of electric conduction at thin aluminum wire sleeve joint.
نویسندگان
چکیده
منابع مشابه
All-Aluminum Thin Film Transistor Fabrication at Room Temperature
Bottom-gate all-aluminum thin film transistors with multi conductor/insulator nanometer heterojunction were investigated in this article. Alumina (Al₂O₃) insulating layer was deposited on the surface of aluminum doping zinc oxide (AZO) conductive layer, as one AZO/Al₂O₃ heterojunction unit. The measurements of transmittance electronic microscopy (TEM) and X-ray reflectivity (XRR) revealed the s...
متن کاملModification of aluminum thin films
We have utilized several processing techniques to locally modify the superconducting transition temperature and the normal state resistivity of aluminum thin films. The techniques of ion implantation, application of a magnetic overlayer, and reactive ion etching have been used to fabricate S-N interfaces with controlled differences in transition temperatures and normal state resistances. Lithog...
متن کاملElectric Flame-Off Characteristics and Fracture Properties of 20 Thin Copper Bonding Wire
In the present study, the neck fracture properties of annealed wire with 1⁄4 20 mm (0.8mil) at 225 C for 1 hour and un-annealed wire were compared. In addition, the microstructural characteristics, the mechanical properties and the texture transition using EBSD methods before and after an electric flame-off (EFO) process were also studied. Experimental results indicate that the recrystallizatio...
متن کاملRecrystallization Effect and Electric Flame-Off Characteristic of Thin Copper Wire
Compared with gold wire, copper wire is cheaper and possesses lower cost, greater strength and better electrical conductivity, and therefore is becoming more commonly used. But the lower ductility and oxidation undermine the reliability of copper wire bonding, making the wire susceptible to breaking. In the present study, the annealed effect (at 150–250 C for 1 hour) on the tensile mechanical p...
متن کاملEvaluation of Thin Copper Wire and Lead-Free Solder Joint Strength by Pullout Tests and Wire Surface Observation
Copper wires have been attracting much attention for Large Scale Integration (LSI) bonding because of their excellent mechanical and electrical properties, in addition to their low material cost. The ends of these wires are usually joined to pads or through-holes on a printed circuit board, and lead-free soldering is one of the popular bonding methods. Since the deformation resistance of solder...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEJ Transactions on Power and Energy
سال: 1986
ISSN: 0385-4213,1348-8147
DOI: 10.1541/ieejpes1972.106.903