Detection of Cracking in Gear Teeth Using Acoustic Emission
نویسندگان
چکیده
منابع مشابه
Identification of the Onset of Cracking in Gear Teeth Using Acoustic Emission
The development of diagnostic methods for gear tooth faults in aerospace power transmission systems is an active research area being driven largely by the interests of military organisations or large aerospace organisations. In aerospace applications, the potential results of gear failure are serious, ranging from increased asset downtime to, at worst, catastrophic failure with life-threatening...
متن کاملA New Acoustic Emission Sensor Based Gear Fault Detection Approach
In order to reduce wind energy costs, prognostics and health management (PHM) of wind turbine is needed to reduce operations and maintenance cost of wind turbines. The major cost on wind turbine repairs is due to gearbox failure. Therefore, developing effective gearbox fault detection tools is important in the PHM of wind turbine. PHM system allows less costly maintenance because it can inform ...
متن کاملAcoustic Emission during Stress Corrosion Cracking Test
AE monitoring from various types of stress corrosion cracking (SCC) has been conducted for the past 15 years in our laboratory. This paper discusses AE results of active-path dissolution-type SCC of austenitic stainless steel in chloride solution and fused salt, fluoride and polythionic acid solutions, brass in ammonia (Mattosson's solution), and carbon steels in nitrite solution. Transgranular...
متن کاملAdvanced, Waveform Based Acoustic Emission Detection of Matrix Cracking in Composites
An advanced, waveform based acoustic emission (AE) system was used to study the initiation of transverse matrix cracking in cross-ply graphite/epoxy (gr/ep) composites. The AE signals were detected with broad band, high fidelity sensors, and digitized for analysis. Plate wave propagation analysis was used to discriminate noise signals from those generated by cracks. The noise signals were confi...
متن کاملStudy of the Frictional Surface Damage Using Acoustic Emission Method
In this study, the change at rubbing surfaces has been investigated experimentally using an acoustic emission signal monitoring system. A steel ring is slipped on the surface of a metallic sheet to simulate frictional conditions. The mechanical disturbances caused by the movement of the ring produce stress waves propagating along the sheet surface. The out of plane displacement of the sheet su...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Mechanics and Materials
سال: 2010
ISSN: 1662-7482
DOI: 10.4028/www.scientific.net/amm.24-25.45