Designing a Die for Hydroforming
نویسندگان
چکیده
منابع مشابه
designing a fast locking pll
a phase-locked loop (pll) based frequency synthesizer is an important circuit that is used in many applications, especially in communication systems such as ethernet receivers, disk drive read/write channels, digital mobile receivers, high-speed memory interfaces, system clock recovery and wireless communication system. other than requiring good signal purity such as low phase noise and low spu...
An Optimization of the New Die Design of Sheet Hydroforming by Taguchi Method
During the last few years, several sheet hydroforming processes have been introduced. Despite the advantages of these methods, they have some limitations. Of the processes, the two main ones are the standard hydroforming and hydromechanical deep drawing. A new sheet hydroforming die set was proposed that has the advantages of both processes and eliminates their limitations. In this method, a po...
متن کاملdesigning and validating a textbook evaluation questionnaire for reading comprehension ii and exploring its relationship with achievement
در هر برنامه آموزشی، مهم ترین فاکتور موثر بر موفقیت دانش آموزان کتاب درسی است (مک دونو و شاو 2003). در حقیقت ، کتاب قلب آموزش زبان انگلیسی است( شلدن 1988). به دلیل اهمیت والای کتاب به عنوان عنصر ضروری کلاس های آموزش زبان ، کتب باید به دقت ارزیابی و انتخاب شده تا از هرگونه تاثیر منفی بر دانش آموزان جلوگیری شود( لیتز). این تحقیق با طراحی پرسش نامه ارزیابی کتاب که فرصت ارزیابی معتبر را به اساتید د...
15 صفحه اول3D Ultrasonic Imaging for Sheet Metal Hydroforming
With fluid forming processes getting more and more common in industrial application a lot of research is carried out to analyze the forming behavior of sheet metal within these processes. In order to gather experimental information about the forming behavior of the workpiece, an imaging system is presented, that will allow determining the actual shape within the forming process. The system has ...
متن کاملOptimum Designing of Forging Preform Die for the H-shaped Parts Using Backward Deformation Method and Neural Networks Algorithm
In a closed die forging process, it is impossible to form complex shapes in one stage, and thus it becomes necessary to use preform dies. In the present study, Backward Deformation Method and FE simulation via ABAQUS software has been used in order to design preform die of the H-shaped parts. In the Backward Deformation Method, the final shape of the part is considered as a starting point and u...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ACTA Universitatis Cibiniensis
سال: 2016
ISSN: 1583-7149
DOI: 10.1515/aucts-2016-0002