DESIGN STATION FOR FAULT TOLERANT CONTROL SYSTEMS
نویسندگان
چکیده
منابع مشابه
Design of Distributed Fault Tolerant Control Systems
When dealing with large-scale complex networked control systems, designing FDI/FTC systems is a very difficult task due to the large number of sensors and actuators spatially distributed and networked connected. Despite the research effort on developing FTC systems for NCS most of these developments still being designed globally leading to centralized FTC solutions inadequate to NCS or, assume ...
متن کاملDesign of Fault Tolerant Control Systems for AHS
This report describes the research work conducted under CALTRANS MOU 288 on fault detection and handling for automated vehicles. The report describes fault detection and handling designs used in the longitudinal control system of platooned automated vehicles. Results are presented on experimental testing of the designs. During the course of the year the project has extended the past work on fau...
متن کاملFault Tolerant Control Design For Takagi-Sugeno Nonlinear Systems
In this paper, a new actuator fault tolerant control strategy is proposed for nonlinear Takagi-Sugeno systems. The proposed control law uses the estimated fault and the error between the faulty system state and a reference system state. A proportional integral observer with unknown inputs is conceived in order to estimate simultaneously states and actuator faults. The problem of design of obser...
متن کاملAdvanced design scheme for fault tolerant distributed networked control systems
This paper addresses the integrated design of fault tolerant distributed networked control systems (NCS). The NCS under consideration consists of two levels. At the lower level, sensors, actuators and local controllers are embedded and networked by sub-nets. They coordinated and supevised by the control stations located at the higher level. The core of the design scheme is the integrated design...
متن کاملSome Basic Ideas for Intelligent Fault Tolerant Control Systems Design
Some basic ideas underlying the EU project IFATIS (intelligent fault tolerant control in integrated systems) are described. Faults in the plant (controlled system) as well as in the controllers (computer systems) are taken into account. Plant modules and controller modules are considered as resources. Needed application functions (partial processes) are to be allocated to such resources to run ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IFAC Proceedings Volumes
سال: 2006
ISSN: 1474-6670
DOI: 10.3182/20060829-4-cn-2909.00171