Design Procedures and Analysis for Single-Phase Variable Reluctance Motors
نویسندگان
چکیده
منابع مشابه
A Design Package for Single Tooth per Stator Pole Switched Reluctance Motors
A design package is developed for a single-tooth per stator pole switched reluctance motor, 6/4. The rather simple assumed flux path method is used to estimate the unaligned permeance including the leakage permeances and the effects of shallow slot and tooth taper. The possibility of making rotor tooth width greater than stator tooth width is examined using the developed package. The result app...
متن کاملOptimum Design Parameters for Synchronous Reluctance Motors
A series of synchronous reluctance motors (RSM) are analysed using finite element methods. The amount of iron in each rotor is kept the same. It is shown that the saliency ratio is not only dependent on the flux guide reluctance factor but also on the position or span of flux guides. It is also shown that an axially laminated design may not be an optimum configuration due to large number of flu...
متن کاملComputer Aided Design for Single-Phase Induction Motors Based on a New Gemoetrical Approach
Design of electrical motors normally involves two main stages: i) Preparation of the main dimensions and parameters. ii) Prediction of the performance. At the first stage the main dimensions of the motor, core stack Lfe and stator outer diameter Do, must be chosen. A set of performance conditions such as breakdown torque, desired output and other important parameters must satisfy the internatio...
متن کاملOptimal design of switched reluctance motors
The fundamental theory of the switched reluctance motor is presented with a number of new equations. It is used to show how the practical development of a design calculation should proceed, and this leads to a discussion of physical characteristics required to achieve satisfactory performance and to reduce acoustic noise. The paper makes a few generic observations on the characteristics of succ...
متن کاملModitication Factor for Sizing Equation of Electrical Machines-Single and Three Phase Induction Motors(RESEARCH NOTE)
Comparison between the results from the design procedure based upon the value of D2L (volume of iron) and IEC standard used by manufacturers indicates that the basic design equation of electrical machines must be modified by a proper modification factor. This modification factor is evaluated for single- and three-phase induction motors and its variation with motor rating and poles number is obt...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Renewable Energy and Power Quality Journal
سال: 2016
ISSN: 2172-038X,2172-038X
DOI: 10.24084/repqj14.273