Design of X-band Core Chip Using 0.25-μm GaAs pHEMT Process
نویسندگان
چکیده
منابع مشابه
Process Optimization for 0.5 μm Dual Recess PHEMT Power Amplifiers
The output power performance of 0.50 um dual recessed pHEMT MMICs designed with current limited load lines strongly depends on the RF current swing of the device. What might seem a sufficient DC Imax of a given sample might not necessarily indicate the intrinsic output power capability of the device. The position and electrochemistry of the wide recess surface were demonstrated as important fac...
متن کاملA low phase noise Ka-band voltage controlled oscillator using 0.15 µm GaAs pHEMT technology
A low phase noise, low dissipated power and small sized Ka-band voltage-controlled oscillator (VCO), using dual cross-coupled pair configuration and capacitance-splitting technique is presented. The Ka-band VCO circuit uses 0.15 μm GaAs pHEMT technology. The VCO has low phase noise, of 116.36 dBc/Hz, at a 1 MHz offset and can be tuned from 30.5 to 31.22 GHz. The figure of merit (FOM) is -192.36...
متن کاملDesign of a K-band Low Insertion Loss Variation Phase Shifter Using 0.18-μm CMOS Process
This paper demonstrates a k-band low insertion loss variation phase shifter with over 330∘continuously phase tuning range from 21-25GHz in standard 0.18-μm CMOS technology. This phase shifter is composed of a 180 ∘ continuously phase tuning range reflection type phase shifter (RTPS) and a 180∘discrete switch type phase shifter (STPS). The measured phase shift range is 336∘with low loss variatio...
متن کاملdesign of an analog fuzzy logic controller chip
fuzzy logic has been developed over the past three decades into a widely applied techinque in classification and control engineering. today fuzzy logic control is one of the most important applications of fuzzy set theory and specially fuzzy logic. there are two general approachs for using of fuzzy control, software and hardware. integrated circuits as a solution for hardware realization are us...
15 صفحه اولDesign and Simulation of an X Band LC VCO
In this paper, a systematic method for the circuit parameters design of a monolithic LC Voltage Controlled Oscillator (VCO) is reported. The method is based on the negative resistance generation technique. As a result, a VCO has been designed in 0.18um CMOS technology using a conventional VCO structure to obtain the optimum values for the phase noise and power consumption. The simulation result...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of Korean Institute of Electromagnetic Engineering and Science
سال: 2018
ISSN: 1226-3133,2288-226X
DOI: 10.5515/kjkiees.2018.29.5.336