Design of triple-band CMOS GPS receiver RF front-end
نویسندگان
چکیده
منابع مشابه
RF front-end architecture for a triple-band CMOS GPS receiver
This paper describes a triple-band global positioning system (GPS) receiver that simultaneously covers the L1, L2, and L5 frequency bands. The proposed receiver uses an image-rejection technique that can separate signals from the three frequency bands to three corresponding ports. It uses a single RF path containing a low-noise amplifier (LNA), and active and passive mixers with a pair of local...
متن کاملCMOS Front-End Circuits of Dual-Band GPS Receiver
A RF front-end chip for a dual-band Global Positioning System (GPS) receiver for L1 and L2 bands is designed using 0.25 μm CMOS technology. All function blocks of the GPS front-end are integrated onto one chip. The low noise amplifier has input matching over a wide frequency range to handle the L1 and L2 bands. This receiver uses a dualband image-reject mixer with the quadrature mixer sharing a...
متن کاملRF Front-End IC Simplifies Software GPS Receiver - Maxim
This article investigates the basic theory of software-based receivers for L1-band civilian GPS applications, including a discussion of signal acquisition and tracking, and the need for bit synchronization in the receiver. Also included is a brief description of an L1-band GPS receiver, the MAX2741, which serves as a compact and inexpensive RF front-end for the receiver. A similar article appea...
متن کاملA 1.57-GHz RF Front-End for Triple Conversion GPS Receiver
A low-power, 1.57-GHz RF front-end for a global positioning system (GPS) receiver has been designed in a 1.0m BiCMOS technology. It consists of a low noise amplifier with 15 dB of gain, a single balanced mixer with 6.3 mS of conversion gm, a Colpitts LC local oscillator, and an emitter coupled logic (ECL) divide-by-eight prescaler. This front-end has a singal sideband (SSB) noise figure of 8.1 ...
متن کاملActive Inductor Designs for RF CMOS Receiver Front - End
Inductors are a necessary building block in many circuits, including LNA and oscillators largely used in Receivers and various other systems. Because planer inductors can occupy a large amount of area in integrated-circuit (IC) designs, the search has been on for smaller, tunable inductors suitable for monolithic fabrication In this paper a method, which is to implement an active inductor by CM...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEICE Electronics Express
سال: 2013
ISSN: 1349-2543
DOI: 10.1587/elex.10.20130126