Design of Transverse Stiffeners in Plate Girders with Corrugated Web
نویسندگان
چکیده
منابع مشابه
Design Requirements for Plate Girders with Bolted Transverse Stiffeners
The web of plate girders in bridges are usually reinforced by welded transverse stiffeners in order to improve their shear capacity.Due to problems associated with field welding and fatigue, welded stiffeners are not suitable for retrofitting existing bridges. Bolted stiffeners are a practical alternative for strengthening girders that are expected to experience shear stress in excess of their ...
متن کاملDesign Requirements for Plate Girders with Bolted Transverse Stiffeners (TECHNICAL NOTE)
Web of plate girders in bridges are usually reinforced by welded transverse stiffeners inorder to improve their shear capacity. Due to problems associated with field welding and fatigue,welded stiffeners are not suitable for retrofitting existing bridges. Bolted stiffeners are a practicalalternative for strengthening girders that are expected to experience shear stresses in excess of theirdesig...
متن کاملDesign aspects of steel I-girders with corrugated steel webs
Corrugated web girders represent a new structural system emerged in the past two decades. The girder’s flanges provide the flexural strength of the girder with no contribution from the corrugated web which provides the girder’s shear capacity. Failure of the web occurs by steel yielding, web buckling or interactively between them. Lateral torsion and local flange buckling of corrugated web gird...
متن کاملModel Studies on Plate Girders
Tests on eighteen small scale models which simulate the elastic and post-buckling behaviour of plate girders when subjected to shear loading are reported and discussed. Themodels were fabricated of steel and Araldite; the major aim was to assess whether small scale models can be employed to study shear buckling problems. A secondary object was to examine whether araldite could be used for predi...
متن کاملFatigue Strength of Fillet-Welded Transverse Stiffeners with Undercuts
Presently, wrapping of the welds at the ends of stiffeners is not done to avoid the undercutting of the stiffener corners and the attendant weld repair. The fatigue performance of stiffeners with undercuts was evaluated in a factorial design fatigue experiment. Undercuts at the flange edge and filling of the stiffener cope with the fillet weld were also evaluated. The undercuts did not influenc...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Periodica Polytechnica Civil Engineering
سال: 2019
ISSN: 1587-3773,0553-6626
DOI: 10.3311/ppci.13819