Design of Porous Structures in Shape Memory Alloy Systems
نویسندگان
چکیده
منابع مشابه
Magnetic Shape Memory Alloy and Actuator Design
In the field of micromechatronics, microrobotics and specially microfactories, active materials are used in most cases. They permit high resolution and distributed actuation. In this area, Magnetic Shape Memory Alloys (MSMA) are possible candidates. If a lot of studies deal with MSMA, only few applications use them until now. MSMA are attractive active materials because they have large strain (...
متن کاملImpact Damage Resistance of Shape Memory Alloy Hybrid Composite Structures
ÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉ. ii ACKNOWLEDGEMENTSÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉ. iv TABLE OF CONTENTSÉÉÉÉÉÉÉÉÉÉÉÉ...ÉÉÉÉÉÉÉÉÉÉÉ vi NOMENCLATURE........................................................................................................ ix LIST OF TABLESÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉ. xi LIST OF FIGURESÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉÉ. xii CHAPTER 1-Introduction and Literature ReviewÉÉÉÉÉÉÉÉÉÉÉÉÉÉ.....
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملSEISMIC OPTIMIZATION OF STEEL SHEAR WALL USING SHAPE MEMORY ALLOY
Nowadays, steel shear walls are used as efficient lateral-load-resistant systems due to their high lateral stiffness and carrying capacity. In this paper, the effect of substituting a shape memory alloy (SMA) material is investigated instead of using conventional steel in the shear wall. A numerical study is conducted using finite element method (FEM) by OpenSees software. For this purpose, at ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2018
ISSN: 1757-899X
DOI: 10.1088/1757-899x/416/1/012016